Caravan fixed heater with 13A plug, should it be PAT tested?

Discuss Caravan fixed heater with 13A plug, should it be PAT tested? in the Electrical Testing & PAT Testing Forum area at ElectriciansForums.net

Share this page

L

logik1

We stayed in a caravan in the last few days which had this fixed air blown heater underneath a wardrobe.

Inside the wardrobe the heater has a 13A mains plug with a PAT test sticker from 2012.

The switch on the front has been broken off and somebody has put in a block connected internally so it's hard wired to always be on.

There are potentially live and hazardous wires reachable through the hole and the caravan sites electrician didn't bat an eyelid and said that the device had previously been tested 'by accident' and didn't need testing as it's a fixed appliance.

There was another identical heater that wasn't broken but also had a PAT test sticker from 2012. Despite all this the caravan site was happy for us to continue our holiday there. We packed up early and came hone.

Does anybody have any thoughts on this?

IMG_20170411_084905234.jpg

IMG_20170411_084924192.jpg
IMG_20170411_084840225.jpg
 
PAT testing is often done in a haphazard and routine way in setups like this.
People are happy to see a correctly dated sticker and I've seen people just update stickers.
I'd be most surprised if the unit isn't supplied by an RCD so as additional protection the risks are lower. However its not a difficult modification to cover the hole and make it even safer.
 
logik1 said:
We stayed in a caravan in the last few days which had this fixed air blown heater underneath a wardrobe.

Inside the wardrobe the heater has a 13A mains plug with a PAT test sticker from 2012.

The switch on the front has been broken off and somebody has put in a block connected internally so it's hard wired to always be on.

There are potentially live and hazardous wires reachable through the hole and the caravan sites electrician didn't bat an eyelid and said that the device had previously been tested 'by accident' and didn't need testing as it's a fixed appliance.

There was another identical heater that wasn't broken but also had a PAT test sticker from 2012. Despite all this the caravan site was happy for us to continue our holiday there. We packed up early and came hone.

Does anybody have any thoughts on this?

View attachment 36192

View attachment 36190
View attachment 36191
Click to expand...
All you can do is report it to the owner in writing, and keep a copy for yourself, just in case.
 
It had been wired in such a way that the only way to turn the heater on and off was to use the switch on the 13A socket.

What worries me though is the exposed access to the wires which nobody seemed to think was a problem. There was talk of gaffer tape and maybe ordering a blanking plate but that was about it.
 
Couold somebody answer YES/NO as to if this appliance should have been kept up to date and PAT tested?

I'm of the opinion that it should and that it would have failed on a visual inspection alone.
 
Forget about it, I have learnt over the years these people don't give a monkeys so don't get involved.
 
Think the answers to your questions are:
1) Should it be tested : Yes
2) Should it be kept up to date : Yes
3) Would it fail visual : Yes
4) Is it dangerous with exposed & accessible Live conductors : Yes
But : As has already been stated, All you can really do is write to the site owner & tell them of your concerns. As for whether any notice will be taken or the issue rectified: Going by past experience, I doubt it.
 

Reply to Caravan fixed heater with 13A plug, should it be PAT tested? in the Electrical Testing & PAT Testing Forum area at ElectriciansForums.net

Share this page

Similar Threads

S
What electrical qualification would be most appropriate to wire caravans/mobile homes?
We have started a business building garden rooms/caravans/mobile homes under the caravan act. We have only done one so far and I got an...
Replies
3
Views
1K
Welchyboy1
W
S
Load Balancing / Voltage stabilization
Hello, I live in Mexico, where I have a small, un-official trailer park on my property. The property is serviced by my privately owned, 650amp...
Replies
9
Views
1K
Megawatt
Megawatt
peeko
CPCs in wrong holes inside consumer unit...x8!
Hi everyone, I've recently done some testing on some welfare trailers used on building sites on behalf of the rental company at their base...
    • Like
Replies
3
Views
2K
diditrain
D
M
Confused about an RCD issue
The full blurb is below, but the TLDR is: RCD that tested perfectly (ramp test to 27mA can't remember the numbers for trip times but all was...
Replies
19
Views
2K
PEG
PEG
G
Static caravans and air conditioning.
Hi Guys. Here's a good one for you, to rack the techies brains out there. Any views on the following please? By the way I'm NICEIC approved, Q.S...
2
Replies
20
Views
7K
GHJT
G

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock