angle

Recent contents Top users
  1. W

    Angle bracket for a floodlight

    Want to install a Ring Floodlight Pro at an angle (say, at almost right angle to wall). Is there a suitable 90 degree bracket that might suit this. Weight of the flood light is about 2.5kg.
  2. _q12x_

    Stepping Motor Angle Rotation using Logic IC's

    This is more a challenge to myself and why not for some of you as well. I will try to make it myself alone but... it will be easier and faster with some more experienced help from you guys. As the title says, with logic IC's. I could/should make it with an arduino or my favorite PIC12F508...
  3. N

    Bode Plots: Phase Angle is asymptotic to -180. What is the gain margin?

    What would be my gain margin if my phase angle doesn't cross -180? Thanks in advance
  4. Carolina

    Horizontal tilt angle of R7s halogen

    Cheers everyone. I'm here trying to install a pair of outdoor R7s floodlights and reading the manual (who does that? I do.) it mentions multiple times the horizontal tilt of the fixture should be "Ideally 0º or <5º" because otherwise the lamp will "burn too fast" with no more clarifications...
  5. R

    Crank angle sensor

    Have a 2010 Mitsubishi Outlander 2.4 petrol it cranks and won’t start. Trying to diagnose if crank angle sensor before replacing as is difficult. I don’t get any error codes besides p1637 which is a memory code. Could this be the problem I didn’t think so? also with obd2 scanner attached when...
  6. Timbo

    Milwaukee M18 angle grinder deal

    115mm paddle switch, quick stop angle grinder body only for £120. Save £50. Tool free blade change...
  7. L

    how to wire the "soft start" of a Bosch GWS8-125 angle grinder

    Hi all, Does anyone know how to wire the "soft start" of a Bosch GWS8-125 angle grinder. There are 3 connectors : blue wire, white wire and a plug-in connector near the blue wire (see pictures). Thank you in advance. B.R. Larry.
  8. T

    18V Makita angle drill

    does anyone use either the makita DDA350Z or DDA351Z a 18v angle drills and what the difference is? Need to invest in one for a big job coming up with a LOT of ceiling joist close togther. Or recommend any other decent battery angle drills?
  9. rolyberkin

    Angle drill for joists

    Does anyone have a dedicated battery angle drill or an attachment, if so are they worth buying? Have to drill out joists at 400mm centres for 15mm pipes and cable runs and was looking at a Dewalt DCD 740N, however wondering whether a drill attachment for £15 do the same job?
  10. loplug

    millwauke angle drill

    any one have any experience of these I have the 18v combi drill impact and sds which I am impressed with the sds so much so I have retierd my bosch 36v. thinking of adding an angle drill for drilling out first fixes.
  11. N

    External Lighting

    Evening all, I've been asked to put some external lighting in for a gentleman I know. It's a large detached property and he wants 4 lights at the front of his house to make it "glow" in the night time. Never installed this sort of lighting, so not too sure which would be the best to use. Need to...
  12. S

    Picture uplights in a flagstone floor?

    Hi all, On a current job the customer decides she wants to light a canvass picture from the floor??? The floor is real heavy flagstone - currently being re-laid. I cant find anything that would be directional enough that can also be trampled on and doesn't cause a trip hazard. I obviously also...
  13. polo1

    Off topic, van security.

    Hi peeps, anyone out there had deadlocks fitted to the lower part of the side sliding door of a Vivaro panel van (2009-14 model)? I've just had this work done, and I'm unhappy with the finished product on the side door. Sure it locks, but the cylinder sits on a slant (the back door lock is...
    • polo1
    • Thread
    • angle electricians vans fitted looks noticed security topic van vehicle
    • Replies: 6
    • Forum: UK Electrical Forum
  14. Energetic

    SCR dimmers/light modulator

    I've got some new LED slimline downlight panels that are supposedly dimmable but need SCR dimmers/light modulator and not a PMW dimmers/light modulator. From the badly translated instructions. I don't get too involved with lighting and the only SCR dimmers i know of are big ones. These three...
  15. A

    Long range PIR - recommendations

    Hello im after a long range PIR detector for a customer, the gate is approx 14/15m from the corner of the house so needs to pick up that far. Any recommendations? All the ones I've seen so far are either very expensive or only have a 12m max range cheers
  16. L

    Angle Grinder Size?

    Hi All Im looking at getting an angle grinder but i am unsure what size to go for. It will be cordless 18v bosch but i dont know which size will best suit my work load. I work on new builds so i need it to cut, cooker hoods, tail protection, minor chasing(just tail runs), light duty tray, core...
  17. B

    Angle grinder

    Hello all! Quick I one here, I'm about to go out and buy an angle grinder for house bashing, need it to chase cable runs ect. Could someone advise on what size to get? I was thinking the 4.5 inch? Bobby
  18. W

    Running cables to a socket

    Hi guys my first post in here its probably common sense but here i go. Im currently an apprentice maintenance electrician so domestic wiring i dont see too much of. My question is for my logbook. I have to run in a radial socket circuit. I know all the usual stuff B20A MCB 2.5mm cable clipped...
  19. uksparks

    Right angle screwdriver

    Hi, for those of you who have not got one, seen one or anything else, my ad picked one of these up for me in screwfix last week, amazingly useful, used it twice already! A right angled screwdriver, you turn the handle and it turns the bit in the end, what a great idea...
  20. G

    Angle Grinder dust extraction..

    Anyone used one of these ? Im ordering a new grinder and considering one but quite expensive. MAKITA DUST EXTRACTION SHROUD TO SUIT 4½?/115mm AND 5?/125mm ANGLE GRINDER | eBay

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock