Hi folks,
I have recently had a 5kW Solis inverter and 15kW/hr of batteries installed. Everything is working fine, but I have some concerns about the quality of the install:
I wasn't given any documentation, so no "part P" documentation.
Around three metres of new meter tails were added -...
Good afternoon, I have a 2 year old car battery (AGM 760 CCA) in a 2022 Hyundai that constantly "seems" to lose its charge. I'll check the battery during the day and, as an example, it will show 40% charge (12.2 volts). I put the trickle charger on it, and within about 15-20 minutes, the...
I will be putting together 2 x 12v lead acid battery connected in series (24v basically) backup power for Internet connectivity (routers/wifi etc)
Looking for recommendation on best way to keep these battery charged for a series connected battery. There's a lot of 12v battery chargers out...
I am a Napit registered electrician and want to get into Solar PV and battery storage. I have boot camp booked in April but am not hearing good reports of the outcome of this training. In the meantime I want to do as much research as possible so want to review the elements that go to make a...
Hi all - just a quick post to say thanks for this excellent resource and to ask a quick question!
PV Panels and battery storage - is there any yearly checks that need to be carried out?
Hi, advice please if this would be fine and not cause issues with either the batteries or the inverter. I have read that LifePo4 batteries aren't compatible with older alternators. So is this workaround ok? - Leave existing leisure batteries as they are (2 x 100 AH) connected parallel, charged...
Hi.
I have just moved into our new home and the battery cover for the Worcester Digistat programmer is missing.
The programmer is: Part number 7 716 114 461 0
I called W_B helpdesk and the offered to sell me a new unit -- but the programmer is working fine.
Might anyone have any spares...
Hi There,
Just wondering if anyone is aware of any devices that automatically preserve vehicle 12V battery life by breaking the circuit once the vehicle is switched off, looking at installing such a device to vehicles in bulk so obviously targeting cost effective solutions and ease of...
Hi All,
Might be a stupid question but I have about 30 of these smart+guard alarmed call point covers to deal with. All the batteries are dead and need changing. Only problem I'm encountering is that you have to unscrew it from the wall to put the new battery in and once the new battery is in...
Hi everyone, I have a basic knowledge of electric but would like advice before I attempt, I have a electrical item that is powered by
Voltage input: ~100-240V/50-60Hz
- Output: DC 24V, 2-3A, I would like to make it portable by just using battery power, preferably rechargeable any help would be...
Hello,
So I purchased a Novopal 2000w/4000w(Peak) Pure Sine Wave Inverter DC 12V to 110V/120V.
I purchased this so I can hook it up directly to my truck's 12 volt battery and have it positioned in the flatbed of my truck..
The goal is to have it power my microwave in my flatbed at drop sites. I...
We have a 5.5kW incoming supply, which cannot practicably be upgraded due to our remote location in the mountains.
Can I use a PV array and battery bank to augment this supply? We don't need lots of power, but with a 1.5kW water heater, a 2kW kettle and the odd 3kW power tool, we keep tripping...
So I'm looking to connect my car's battery directly to a Pure Sine Wave 2000w power inverter So I can use it on job sites etc to power a microwave of above 1700 watts.
My question would be, Do I need to have a one-way fuse in my wire setup directly from the battery to the inverter? Or can it be...
have a set of lights that i would like to use plug over battery.
have a few plugs and old sets with cables could Frankenstein together if doable.
this is the set if anyone has any suggestions on how/what min transformer plug would be required.
its a 20m set and i have another 20m set so...
hello guys i have a (3-6v dc motor), (DC Motor PWM Speed Controller 3V 6V 12V 24V 35V), (3.7v 1200mah rechargeable battery) and a (Charging / discharging circuit MH-CD42 for batteries with 5V output). Everything looks to be working fine it spins and everything but when i put force on the motors...
stair lift was off its charging section at top of stairlift track for some time rarly used. and upon checking batteries were dead. could not move back to charging section.
put in two new batteries
then with buttons managed to get it up to top of track, however it went s little too far and...
Hello everyone,
I'm currently working on a project to upgrade an existing renewable energy system and could really use some expert advice. The goal is to maximize self-consumption and minimize grid dependency while incorporating new components.
Current System:
Wind Turbine: 5KW grid-tied...
Hello
I am hoping someone can point me in the right direction. I have 4 x new Lipo rechargeable batteries 2900mAh 11.1v (32Wh) 35C constant and 65c discharge bursts (?? pass!). I would like to use them to power a car cam (not being used for a car) which has a micro power connection (like a USB...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.