led

Recent contents Top users
  1. G

    Led tape driver

    Hello, Does anyone know of a Driver for led tape that can adjust the brightness on the driver itself by turning a screw etc ? Just need something I can adjust to the correct level and then leave behind a panel and just switch off and on with a lightswitch .
  2. N

    Running LED bar in series

    Hey all, I'm not sure if I'm over thinking this, but I can't seem to find the answer to what I believe should be a simple question. I picked up two 12VDC 5W 108 LED light bars. I'll be attaching both to the same power supply. My question is can I run them in series? Each light has a switch, as...
  3. oosti_1

    12v Solar camp light setup

    Hello, I'm new to this and I'm looking for someone to review my wiring diagram. I'm not sure if I need a fuse block because I'm using an XTM branded kit that includes 4 LED light strips. They advertise that this can connect directly to a battery with alligator clips. XTM 4 Bar Light Kit -...
  4. I

    Driving LED Chip

    Hi everyone, I would like to use LED chips for DIY projects, to power them I would start from 12V drivers for LED strips. For some chips it is necessary to convert the 12v to 3 or 6v. Could you recommend some products that are easily available online? If not, someone can advise me where to...
  5. R

    Connect Led fixture 2 wires, to ceiling light with 4 wires.

    I have 2 lights connected to 1 switch. I installed a led light fixture on one light, it had one red wire and one black wires. It was easy to match the wires to the led light fixture. The 2nd light has 2 red and 2 black. Because the 2 lights are wired together. How do I put a led light fixture on...
  6. P

    Can I mix Fluorescent and LED ?

    I have three Aurora Fluorescent linkable (linked) under cabinet 'strip' lights (c.21cm each) under the kitchen cabinets and over the sink area (but not directly above) put in by the builders in 2006 when it was built. The middle Aurora strip light has failed and needs replacing - the Aurora...
  7. R

    Italian LED Floodlight Moisture Issue

    I'm from Sri Lanka. We have installed LED Floodlights from two different Italian Brands (I can mention the names if wanted) on two different sports grounds. Both fixtures are IP66 protected. Yet, both types had the issue of retaining water (mostly moisture) inside the LED compartment. This led...
  8. C

    Anything to consider replacing below-cupboard kitchen LED lights?

    We bought a house with an array of broken (some cosmetic issues, some functional) downlights under cupboards in our kitchen. The bulb seem to be integrated into long wires and tracing them back up it seems there's a bunch of what I presume LED drivers on top of the cupboards. Should I be...
  9. D

    LED replacement for 90v E27 frosted/pearl glass bulb

    Hi all. Slightly out of the ordinary, but I'm looking to replacing between 60 to 100 standard size E27 bulbs with LED equivalent. The catch is the LED must run at 90v, rather than 230v. "Why?" you ask, these bulbs are used in heritage diesel-electric pulled coaches and we're looking to 1)...
  10. G

    Fixing recessed LED ceiling profile in place

    Hi, want to installed some LED strips in the ceiling and wanted to know how the recessed LED profile is fixed in place and stop the plasterboard from cracking or sagging when it is running parrallel to the ceiling joists. Has anyone done this? Thanks
  11. J

    Dimmer Switch - LED

    our dimmer switch stopped working after 7 years so went to replace it at the weekend. When I opened it up, the black wire was in the common slot and the red wire was in L1 which i thought odd because i thought it needed to be the other way around. Anyway as it had worked for so long that way...
  12. A

    Hiding led strip driver in bedroom?

    Hi everyone I’m after some advice please. I’m installing some LED profile around a customers bedroom ceiling for some led strip to sit in and diffuser on top obviously. My question is how do people hide the driver? In ceiling void and drop in through back of driver? But most are plug top...
  13. GeoPag

    Rewiring Medicine cabinet to accept LED light tubes

    Hi, I am restoring an old art deco, wall mount medicine cabinet. The cabinet has an 18” fluorescent light tube on each side. Before I put a lot of money into restoring this (mostly chroming parts) I want to make sure I can get lights for it, preferably LEDs, and need to know what I should...
  14. J

    Replacing led bulbs

    Hi I currently have 4 led bulbs in the bathroom and 3 of them arent working. The bulbs that are currently in are LOMAS LED GU10 220-240V 6000k 6w Not-Dim. I cant find any 6w online would it be okay to fit a 4.6w? Also the bulb doesnt say what colour they are what would they be? Or should i just...
  15. Mark Wright

    LED flickering in cold staffroom

    Most of the replaced halogen lights are flickering something terrible until the room warms up? Never heard of this. Any ideas? O and there GU5.3s
  16. I

    Will LED Bulbs have a shorter Lifespan in a Light fitting designed for Halogen

    Hi we are replacing light fittings in our home. Im confident with the fitting aspect, but have run into doubt in making the right choice of fitting.The one we like says it recommends G9 Halogen bulbs Buy Clear Drizzle 3 Light Flush Ceiling Light from the Next UK online shop -...
  17. J

    LED spotlight to illuminate war memorial

    I'm looking for an LED spotlight that can be mounted on an existing lighting column. The aim is to illuminate a war memorial that is 20m away. Any recommendations on where or what I should be looking at?
  18. dlt27

    LED High bays flashing!!

    Hi all, any advice would be greatly appreciated. Went to do some work at a factory unit on Monday ( changed 20 florries to LED battens and changed 20 400w metal halide to 150w LED high bays). The florries were fed from different circuits and different DB’s and the high bays were fed of one DB...
  19. S

    Halogen to LED (dimmable)

    Hi all I've been changing the halogen downlighters in my house to LED's. I have three rooms that use dimmers, two of them have two switches each to control the lights, all rocker type dimmer switches. I've had no issue replacing the dimmer modules in the rooms with multiple switches as they are...
  20. J

    can keyboard led glow on

    Hello Can keyboard led on when i remove data pin Data Clock will caps on without data and clock

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock