position

  1. S

    Electrician Jobs 17th edition Electrician required mid Cornwall Permanent Pos.

    We are looking to take on electricians to our fairly small team nr. Truro in Cornwall. Applicants must have: A clean drivers licence 17th edition 2391 testing or similar and be able to work alone or as part of a team. Ideally we are looking for an employed position offering 40hrs per week but...
  2. S

    I Need Work 17th edition Electrician needed in mid Cornwall

    We are looking to take on electricians to our fairly small team nr. Truro in Cornwall. Applicants must have: A clean drivers licence 17th edition 2391 testing or similar and be able to work alone or as part of a team. Ideally we are looking for an employed position offering 40hrs per week but...
  3. D

    On/On/On or On/Off/On Light switch?

    Looking at doing a PIR Outdoor Light for my sister. Wonder if there is a On/On/On or On/Off/On light switch, i can get them in Electronics Just means i could have it set to PIR / Off / Always On If i look up such switches i get Electronics and if i look up Light Switches i get normal bog...
  4. D

    Help with positioning flex outlet to heater

    I am preparing the way for a local electrician to connect up a water filled electric towel rail 300w from an RCBO in the CU by installing some conduit within my internal wall cavity. He hasn't been around to look at the job yet, so my question is: Does the cable outlet position have to be above...
  5. Startinez

    Cost of moving supply intake position

    Evening all, Unfortunately no picture on this scenario until I move into my new house on the 25th, so hopefully my words do it justice. The house that I am moving into has a small area underneath the stairs that we would ideally (eventually) like to make into a toilet as the house is single...
  6. Eco Chap

    I Need Work Electrician Required Full Time - Shropshire

    Evening all, We have a position opened up for a fully qualified sparks in the West Mids/Shrops area. Mainly to carry out Domestic works but Commercial experience would be a bonus as the need may arise to bounce around contracts. Vehicle provided along with power tools, must have own hand...
  7. Lee Gold

    Electricians mate

    I'm looking on doing electricians mate job, but not sure how to go about doing it. I currently do electrical maintenance industrial but want to do domestic and or commercial. I go night school 2 days a week 3 hours a lesson and it's a level 1 course, what do I need to be able to apply to be an...
  8. Darkwood

    The dangers of condensation!

    Got a callout from a mate saying his light are out and all circuits are on, also he thinks something smells funny so given the latter info I said it best I pop over and check it out, now considering I went to look at the lighting issue, what I found in the board was an example of the issues of...
  9. M

    Can You Change The Position Of An Isolator?

    Hi, I just bought a house with a consumer unit which works fine but the isolator switch has been moved to the opposite side. It would have originally been on the right and has been moved to the left. It's clearly labeled with stickers etc but there's a molded on/off symbol on the right. Would...
  10. W

    Kende Switch

    I have a Powercraft 25-130 welder the selector switch was stuck, it is a 6 position 0-6 Kende Switch with 4 banks,I took it separate and put it back together but what I need to know now is,when the switch is on position 1 what continuity readings should I get between the the different points on...
  11. D

    Generator light problem in my 65 Buick

    Hey guys, I'm new to the site as I'm experiencing a problem with my electrical system in my 65 Buick Sportwagon. This is what I did. The car was charging fine but at idle the light would flicker and the GEN light would lightly glow, which would go out once I gave it gas. So I took out the...
  12. P

    British Gas UP2 failing to turn on Central Heating except when Hot Water is on

    OK, so I'm not a plumber but have a fairly good idea how this system works. I'm not alone with this problem either, there has been a similar post but it's old and doesn't have a resolution - though they have a temporary fix that doesn't work for me... Boiler: Baxi Solo 15HE Controller: BG UP2...
  13. T

    cooker switch above new hob

    Evening chaps!! I'm after a bit of advice, I'm booked to do a job the weekend. The client has brought a new dual cooker/hob, the company who was to install it refused due to the cooker switch now being above the hob. I have not seen the job yet but apparently running a new 6mm to the correct...
  14. M

    Eicr codeing

    Hi, What code would people put for a lighting cable going along skirting board with no trunking ect, its in a really old building so not sure weather this complied then or not as its in an exposed position, i want to put c2 But is it c3 Would be thankful for your input Regards Kurtis Randle
  15. J

    Isolator position for immersion heater?

    Hi everyone, just after some advice. I've wired a new s plan system which has gone fine. plumber has installed a pressurised tank in loft and I have wired the immersion to the customers off peak supply. The isolator for the immersion is in the Airing cupboard along with wiring centre and...
  16. A

    **Seeking Electrician mate/Improver position**

    Hi, I am currently on the last stretch of my C&G 2365 level 2. As of June I will be qualified to electrician mate level. Currently work full time, but not in this trade. I am also enrolled for another two years at college, part time, two evenings a week to obtain level 3 C&G 2365 L3. Self...
  17. yellowvanman

    Move light position?

    Extension wiring. Included in this was some wall lights, and with the shape of the extension, drop from ceiling is about 3 meters. Cables have been in for weeks, dot and dabbed and plastered. Lights were positioned in the middle of a wall at 2m height from floor. Now customer asks 'can you...
  18. K

    Consumer unit position

    Evening all. My landlord is developing property and asked me today about the positioning of four consumer units for four separate units. His electrician has suggested putting the ccu's for all four flats underneath a communal staircase cupboard next to the distributors meters 'to save money'...
  19. D

    How much space to set aside for DNO

    Hi Just to make sure I have this covered, how much space do the DNO & provider normally require for the fuse unit and meter? And what is the preferred height? KR Mark
  20. M

    Mid position valve and underfloor heating

    Hi all, just installed a polypipe under floor heating system to an existing Y plan, the valve is a V4073A,with this system the UFH stat should independently operate the UFHeating from the existing central heating, the snag is with the time clock off and the UFHeating stat on both the UFH & the...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock