2 fuse sockets on the same leg of the cartridge fuse are not working. The fuses (15 amp) do not blow - just don't have power. I have power coming from the pole and both cartridge fuses are good. The other 2 fuses on the other leg work fine. Stumped.
I've bought a ring wired doorbell and I've run in to a spot of bother trying to install it.
The transformer is above my connection box in the hall cupboard. The chime is through the wall next to my front door. It says to attach the jumper cable to the trans and front terminals none of the...
Unfortunately my electrician is too busy installing EVs so I've kinda been left on my own for now! I have an issue where the RCD labelled #1 in the attached picture trips as soon as I attempt to turn the immersion heater on. I've had the immersion heater replaced (well, I couldn't get it out...
I have an unusual problem and need some help. I've never run into this issue but any help would be appreciated. We have two dwellings on one service. The first is a mobile home and the second is an old shop that has been converted into a dwelling. It is a 200 amp service. The issue is that...
I've inherited a home with wiring in place but not all connected. I can't locate the original electrician who did the work about 2+ years ago.
I have four switches. Line power goes into switch 1 (a 3-way switch) then over via 3-wire cable to switch 2 which has a feed to 4 can lights (install a 4...
I know this is a forum for electrical problems but I can't find a forum for burglar alams (is there one?)
Bye the by one of you may have an answer . . . .
My alarm system (Accenta G3 mini) was installed a long time ago (maybe 20 years). The system was working fine until I changed the battery...
I have a grundfos sololift 2 wc1 macerator that isn't working. It's about 3 years old. When the toilet flushes the bowl just fills up but the motor does not kick in. There is power going to the unit, The macerator motor/pump turns freely. I took the motor apart in the hope that there may be...
I have a 4kw system and a Solic 200 installed - all good since installation.
I had a Solis inverter and Pylontech battery installed, but the Solic and Inverter do not work together! The Solic boost button does not work and I have the warning lights.
I had hoped and asked the installer that if...
Hi,
I have got this DC to AC power inverter that draws excessive amount of power when I start up a motor.
The motor is a 1300W one and my other inverter draws 1800W on start up, the one with a problem takes 3200W.
It's a low frequency inverter with simple power board and a large coil. I have...
Last couple of days, the forum runs slow.
It can be fine when first opened, then after a couple of minutes freezes, or I get an error message.
This is using forum on iPhone 11, haven’t tried laptop yet.
Closing Safari down, then reopening seems to help… but a few minutes later, it happens...
Hi all, I am hoping someone can help me with my problem. Just started renting a place and it has under cabinet LED lighting in the kitchen. It's connected to a wall switch but it takes anywhere from 2 to 50 flicks of the switch before the lights come one. I have tried slow on/off patterns, long...
Hello all,
Ran into a curious issue last night with my basement light circuit - here are the details of the circuit (diagram also attached):
15a AFCI\GFCI combo breaker in panel
3 Switches (2x 3-Way Switches and 1x 4-Way Switch in the middle where the power comes in)
Load - series of light...
So, This is the Main disconnect for a Panel that provides Heat to units.
I shut off the Main. Worked on the panel. Went back to energize the Main Disconnect and this is What happened.
I recently had a solar installation at my home. Immediately afterward, a GFCI outlet in my garage stopped working, had no power, and could not be reset. At the same time, my two outdoor outlets stopped working. I first checked the new breaker box the solar installers put. However, no breaker was...
Hello everyone
I hope you all well,,
I have a question regarding old method install rosy lights-switch and connect in the box,I have a problem with one fault sort it ,the light doesn’t work,I needed help,I have experi connect in the switch…
I have 4 1w LED marker lights AU-WU682/1R in the ceiling with a AU-LEDD16CC driver in the loft. In the same bathroom I have 3 of the same marker lights in the floor with a AU-LEDD16CC driver in the room below. The dimmer switch I have is SF2184BC 5-150w. Each set of marker lights are currently...
Hey guys, hoping someone can help with my problem.! A client of mine asked me to rig-up a little solar system to power a diaphragm air pump (230V/3A) for a cesspit.
Solar/low voltage isn't something that I'm that familiar with (I'm a sparks), would have much rather just laid some new armoured...
Re: Danfoss FP715Si Programmer
Anyone have any direct experience with this unit?
NB: There are quite a lot of posts online about this issue, but nothing I have found that has found the cause.
This Danfoss FP715Si Programmer that works fine.
But the following situation occurs from time to time...
Hi I was trying to get some help with this problem I’m having in my house , I recently did some remodeling in my home and decided to put a dedicated sercuit for each of my bedroom because before they where all jumped together I also added new lighting to my kitchen and added a bedroom to my...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.