To be honest, we are a new smart thermostat and TRV manufacturer and are working hard to create our first thermostat, we want to make a product that users are loving and that is really useful to users, can you help give your feedback on these designs suggestions? Any help would be greatly...
It has become a common occurrence that my boiler is failing to respond when the thermostat kicks in.
I hear an audible click from the heatlink when thermostat is turned up but nothing else happens.
Our heating programmer next to the water cylinder is set to continuous and all looks OK.
The...
Hello, I'm in the process of changing my wired remeha thermostat with the wireless hive mini, I've had a look at the manual and believe I have installed this correctly however the thermostat doesn't seem to be talking to the boiler and I can't control my heating through it.
Could you please...
I would like to replace my ancient Honeywell mechanical thermostat with a Honeywell T3R PROGRAMMABLE THERMOSTAT
I have three wires in the old thermostat. Please see the first three photos.
1 Red
3 Yellow
2 Blue
are these
1 Live
3 Live return (Switched)
2 Neutral
Could I configure it as in...
So as the title says, I have 3 panel heaters in my flat, but only one really needs the fine control i'm after, the other two rarely go on even in dead winter as i'm stingy and my flat is small.
The heaters are mains connected (no plug sockets) so i'm looking for something that ideally will go...
Trying to install a smart thermostat,
I have 4 wires red, yellow, blue and earth,
And this smart meter wiring diagram baffles me.
1st photo old thermostat,
We've just bought a house with Maincor underfloor heating with programmable room stats.
I'd like to change these to nest stats so I can have remote control. Does anyone know if this is possible?
The maincor stats just have 240v L + N feed and a wire running back to the wiring centre. This wire...
Hi,
I'm looking for some help with an UFH thermostat that I can't find the model of. All I can see is that it's made by Rehau. Installed roughly 2008-09.
I'm trying to set the schedule on the device but the symbols aren't obvious what they are trying to communicate so I want to find the manual...
Hi. I have very old underfloor heating with thermostats. I'd like to replace the thermostats with timer/thermostats if possible. The current (very old) ones have 2 red cables, 2 black and an earth. One of the red cables is live all the time, the other live when the thermostat kicks in. It...
Customer lives in an old farmhouse, part of which was converted into 2 B&B apartments. The owner has had 2 additional zones added to the main house central heating system, a zone for each apartment. The plumber has done his bit, and installed zone valves onto the pipework, but not connected...
the simple heating device is just a plug and a 220v 300W spiral thing. I would like to add a 12v or 24v fan from a laptop just to make the whole place warm and not just a corner. Needs overheating cut off as well I guess would be the minimum requirement.
Want to do this safely at low low cost...
For a roof top boiler enclosure that is really way too hot in this weather .Plan to have large vents at the bottom and to use a Room stat set up to run a 6 inch bathroom fan etc to come on when it hits 25 degrees inside. This morning it was reading 47 degrees inside ! Using the room stat in...
Hi there,
I've had 4 plumbers & 1 electrician look at my problem (seemingly without dedicating too much time unfortunately), spending more than £1000 already 😣, but none of them has found the issue to my problem - that's why I'm reaching out to you!
I have the below set up
1x gas system...
Hello,
I have a piece of equipment with a thermostat attached to the bottom to heat a tank. This has stopped working- the red light does not turn on and it no longer heats up. The thermostat still clicks when twisted. I have attached a photo - I have used a voltage tester to test if...
How is the above (wired type) installed in a normal? S plan where the room stat(s) are fed from the programmer so a switched live, does the Honeywell have batteries as I think I've read somewhere that it needs a permanent live. Two wire stat presently installed with supply (switched) from the...
I have a 4kW immersion heater in a thermalstore - very recently replaced by a plumber as the previous one was leaking. Supplied with a cotherm thermostat and a second pocket for a safety cutout into which the safety cutout from the previous immersion was fitted and seems to be working fine.
I...
All of the UFH thermostats that I have ever fitted have had the air temperature sensor integrated into the hard-wired wall mounted programmer, with the floor temp sensor cable also connected directly to it.
I have a small UFH job where the UFH will be the primary heat source, so an air sensor...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.