within

  1. D

    Asbestos within a Db

    Hi all, we have a number of electrical DBS across site with asbestos present within. Can anyone recommend an electrical contractor who can handle, remove and dispose of the asbestos, as the same time providing a replacement db. We have serval sites across the uk, but ashford, Kent and...
  2. Cjm1992

    Cables within stud walls

    Hi All, Wondering if I can get some advice. Basically I’m having exposed joist ceilings in my house and I’m in the process of slowly changing all the cables over to new. Currently I have 2 sockets within the lounge area chased into the brick plaster walls however I’m potentially looking to...
  3. T

    Fixing's within an ISO shipping conatiner

    Hi all, I'm looking for any advice with regards to fixing equipment to the inside of an ISO shipping container. New DB, lights, sockets, switches etc. Just looking for a recommended method of fixing to the container itself. Any help would be appreciated. Thanks in advance
  4. littlespark

    Adverts within thread posts

    On some threads, where there are a large number of posts, there are adverts inside posts. (Might be in between?) but at least they are forum sponsors and not some random clickbait. Again, I’m not sure if this has always been like that, or it’s by design. Neither of these issues are massive...
  5. P

    Is it within the regs to fit sockets without securing them to a wall/cupboard?

    Hi, moved into a new home and the sockets for the fridge and freezer have just been left loose on the floor behind the kitchen cupboard base trim. To me this look like a rough installation but Persimmon insist it is within the regs. Can anyone confirm and if it isn't do you know which reg I can...
  6. S

    Having a house re-wire, are old back boxes within new regs?

    Hi, Glad to have found a good forum to ask my electric related questions. So my property had old vir cables nearly throughout and ceramic fuses. The company doing the rewire is 3/4 of the way through, but I have a few questions. 1. Are the original light switch back boxes still under current...
  7. P

    ventilation within computer room

    the computer server room is protected by a gas suppression system apart from CRAC units, should a ventilation fresh air and extract system be installed in the room
  8. P

    C02 sensors within multifloor office building

    i am working in an office building that has several C02 sensors. They sense C02 levels only within offices that are enclosed where are C02 sensors normally installed within a ventilation system, what is the normal parameter set points and what is the normal cause and effect
  9. P

    C02 set points within AHU

    Hi All Why are C02 set points within car park ventilations systems different from office ventilation
  10. N

    Need advice: Dark shadows developed in screens of 4 different devices within six weeks. May this be an electrical issue?

    Hi guys! I'm new to the forum and seek advice on an issue that I have been experiencing in my flat in Ireland. I'm not an electrical professional and only have a superficial knowledge of most topics in this regard. I am experiencing the following issue: Over the last two months, I had 4...
  11. M

    Conversion to TNCS within property. A concern? And EICR code?

    Hi all Have attached photo. Was inspecting property earlier in residential apartments and as you can see the supply has been converted to TNCS within the property and after the meter. This is the first time I have come across this before. I'm led to believe any TNCS conversion should be done...
  12. MikeMaMan

    blank plate within 300mm from the cooker?

    hi. i know what sockets most be at least 300mm from the cooker. but if socket is removed and blank plate installed, does it still need to be 300 mm away form the cooker?
  13. W

    Eicr code for spurs within bathroom zone 2 but inside cabinet

    Hi all Eicr being undertaken, what code if any would you consider for this scinario Small bathroom in a flat, with airing cupboard inside, no room for immersion and pump spurs (looks like spurs was inside airing cupboard at one point but cupboard has been made smaller to enlarge bathroom and...
  14. A

    I’m in need of an electrical job as a electricians mate while I study level 3. Is there any one who can help me out within London?

    I’m currently studying level 3 electrical. While working on a demolition site which is getting me site experience but now on the electrical side. So I am hoping some one can help me gain experience on the electrical side. I’ll attach my CV so if any one can loom though and see if they can...
  15. G

    What Code for this one?

    What code would you attach to this gem, I gave it C2. These terminals are contained within steel trunking but are also part of a live 3 phase cct. See picture. It is installed as a 100 Amp 3 phase ring with these terminals every few metres. Distribution boards are connected from these terminals...
  16. A

    Rose circuit bedroom wiring mayhem, 3 blacks dosnt work!!!

    After purchace of three debanhams lights and sucessfull fitting of 2 the third has caused me some unrest due to an ensuite bathroom within the circuit. 1) Presented with three reds and three blacks i wired the three reds togther. Wire 2 blacks into a sucessfull bedroom switch leaving one...
  17. ThatMatt72

    UK Can't get within maximum load when applying diversity

    Hi all, I wonder if you might chuck in your 10 cents worth on this on? I have been asked to install electric heating in an office up on the 4th floor of a building. I've looked at the layout of the room, with regards of seating etc and after consulting with the occupiers have decided on the...
  18. Thomas Simons

    RCD Protection for lighting within communal parts

    I'm due to start working in a building which houses lots of flats over 6 floors with 2 internal communal stairs. I'm due to replace 13 ceiling lights per floor/stairs from a halogen bulkhead to a ELD 17w LED microwave/emergency bulkhead. Each floor is fed from a Square D B6 QOE MCB on a 3...
  19. M

    Leave existing ceiling rose within new metal light fitting??

    I'm your average DIYer and after advice about replacing a pendant light with a new flush metal fitting. I can fix the new light to the ceiling and the existing rose sits within the void of the new fitting without any clearance issues. Is it OK to leave it in place and wire the new fitting into...
  20. O

    Which Publication is this?

    This picture was sent to me by a plumber - so I'm guessing its some form of plumbing or gas safe regs He was saying the bond HAD to be within 600mm and that my regs (BS 7671 AMD3 were wrong!) So I was wondering is this is the document above that needs changing to reflect the proper description!

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock