aurora

Recent contents Top users
  1. S

    Aurora Power-One - zero Riso.

    Hi all. Long story short - my Aurora P-One developed the common E031 fault. I carried out the repair myself (ex electronics teacher), replacing the 4 relays. On refitting, it returned a Riso - 0Mohm fault. Assuming I'd messed up somewhere, I bought an exchange unit from a reputable source, and...
  2. U

    Are replacement Aurora Power One PVI 3.0/3.6 inverters still failing ?

    My original inverter installed in 2012 was replaced by ABB in 2016 after failing with a E031 error, my replacement is now getting around 6 year old mark i’m wondering if the replacements have the same issue as the originals ? The replacement unit is well out of warranty now and ABB no longer...
  3. G

    Aurora 5000 with RISO LOW 0,1, MOHM problem

    Two Auroras 9 years old 3000 and 5000 with 4 strings total. Only 5000 has RISO LOW GIF Red problem. Even after switching strings between 3000 and 5000 the problem remains on the Aurora 5000 and all strings seem to be OK.. Any suggestions what may be wrong with this unit installed in very dry place.
  4. W

    G4 LED's & Aurora AU-LED16T 12v constant 16W LED Driver, does it matter about the polarity ?

    Using these lights (wired in parallel) 6 x 2W is ok to use a 12V constant voltage 16W led driver Aurora AU-LED16T. My question is they are a G4 fitting which goes, either way, does the polarity of the bulb cause an issue or do electronics inside take care of this. Many thanks in advance.
    • woodersd
    • Thread
    • 12v aurora constant driver led led's matter polarity
    • Replies: 4
    • Forum: Lighting Forum
  5. J

    Aurora Enlite LED downlights and a dimmer switch

    Hi all, I'm not sure if anyone can help but I'm looking for some advice on LED downlights and dimmer switches. First of all I'm not an electrician and I don't intend to try and carry out any changes myself I'm just looking for some guidance. A few years back a local electrician completed an...
  6. G

    Replacement for discontinued Aurora integrated downlight

    Hi, my bathroom downlight has started flickering. it is an integrated 9w lamp from Aurora, which appears to be discontinued. The lamp plugs into a socket in the roof simply enough and I have managed to plug into the same socket another Aurora lamp in the bathroom which works fine, indicating...
  7. B

    Solar PV insulation fault ABB aurora inverter.

    Hi guys, I am new to the forum so be nice! I used to install solar PV systems back when the tariffs were still good, and I've never had to go back to one of my old installs because of a fault, so I'm not too clued up with regards to fault finding on PV. A customer has recently called me out to...
  8. U

    Looking for Aurora Communicator v2.10.1 software

    Anyone got the install software for Aurora Communicator v2.10.1 software I believe there may even be a 2.10.2 version.. I had an issue with my server and need to reinstall it. Thanks in advance
  9. Z

    Aurora power one 3.6 not start

    Hi everyone. Hello from Poland My uncle give me inverter Aurora Pvi 3.6 He told me when disconnect Pv panels the cable made a short circuit to the ground I open it. Inside its nothing burned (I think)? When I connect to AC grid inverter not start. No errors, no message BTW it's dead ? Maybe...
  10. Electrical2go

    Aurora AOne Now Available at Electrical2Go.co.uk

    Don't forget to get in touch for your 5% discount code. Available to all members Remember you only enter the code once upon sign up, and the discount is applied automatically at checkout each and every time you order. So if you have an account already on Electrical2Go and you aren't yet...
  11. J

    Error E014 (overtemperature) in Aurora PVI 3600 invertor

    Does anyone know if there is a typical fix for this? Someone has given me their old inverter because of of the error code.
  12. O

    Re Aurora Enlite E6PRO

    Has any one had an issue with Simmons the E6PRO downlights? Fitted 6 and 3 dim to a different level to the others, really noticeable
  13. R

    Solar Aurora inverter issue

    Newby from Tasmania. After replacing failed Zetter a/c relay following 031, a quick, cheap and simple operation, there is now an intermittent 013 fault indicating Wrong Mode. Sometimes inverter operates for hours without failure sometimes only a few seconds. During the automatic restart...
  14. Top Cat

    Aurora AU-WU 691/35 walk over light.

    Got called to a place today for some of these lights not working. I can't get at the lamp! It looks as though you need a tool to unscrew the front. Anyone worked on this fitting? This is a picture of it from a website:-Aurora IP65 MR11 20 Watt 12 Volt Walkover Light -...
  15. P

    Aurora Power One PVI 3600 Inverter

    We have one of these and whilst getting a 'clock fail' fail message for a while, we also had to keep powering it down and up again each morning to clear a GFI error, and to get it to start generating. We've replaced the battery with the help of aurora power one inverter -...
  16. C

    AURORA POWER ONE 3.6 Fault

    Hi, Solar panels fitted by PV Solar UK 2011. They are now showing as in liquidation. They Inverter replaced last year free of charge, within guarantee period. Current one has FF80 fault not displaying time-date-production total every 20 seconds. No lights on inverter panel at the bottom. I...
  17. M

    PV Final Design and Permit Packet Option?

    Hello Everyone, I currently work for a startup solar company as a proposal generator. As of now, I create the proposals using Aurora and then outsource to a partner for fulfillment - site survey, final design, etc. I'm looking into keeping the final design internal, but not sure what options...
  18. O

    Aurora AU-FRLD913 9w

    Chaps I don't install these so have no idea about the reliability etc. Got a client who has about 28 of them in 4 rooms - 3 of the 4 rooms are on dimmers and the reliability of these is poor. Is this typical? Are there dimmers that people would definitely recommend? Sorry don't know the make...
  19. W

    fire-stopping cables passing through a ceiling

    i am working in a block of flats, i have Twin&e cable through a ceiling to a light fitting, the cable penetrates the fire barrier which is double plaster board construction. whats the best way of fire-stopping?
  20. Dan

    Aurora - Ever Been Lucky Enough To See It?

    This is on my list. Still haven't seen it yet it's been on my list for years. Anybody been lucky enough to see one of them, if so where and how? I've seen a couple of cruises where they say if you don't see it after a couple of weeks you get your money back.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock