auto

Recent contents Top users
  1. M

    Auto switch not working on control panel for pump

    Hi having problem with my automatic sump control board the switch, for rain water pump, is not going onto auto mode when the water level reaches the float and the red light starts flashing and i have switch to manual I'm thinking the problem lies with the swich,marked K1 is there anyway i can...
  2. J

    UK Three phase dust extraction auto start

    Hello, I am currently working with 2 separate circuits, one for the dust extraction and another for a circular saw. Both circuits have an isolator with 3 phase and neutral then each goes off to its own dol starter. I was wondering if there is a way to make them both turn on at the same time...
  3. E

    Auto transfer switch caught on fire - should we be concerned about our house electrical system?

    Here’s what happened, we’re looking for a professional opinion: The auto transfer switch for our Generac stand by generator “exploded” (we heard a bang and the house shook a bit) and subsequently caught on fire earlier this week. It was mounted to an exterior wall. The generator was installed 8...
  4. E

    How are auto piggy back fuses connected to the fuse block.

    I am getting conflicting information on piggy back fuses that I am using in my Honda CRV and Ram Promaster 3500. I assumed that the piggy back fuse connector was a bridge between the hot and the ground bus in the fuse block and hence was independent from the fused circuit that was using that...
  5. M

    Wire an auto switch using two feeds.

    I registered as a DIY because it looked like the best option for my situation but am not really a DIY because I always hire an electrician so I will not be doing the work, however my electrician did not know how this could be done. She is extremely busy so I said I would check on the internet...
  6. P

    Auto Electrical - LED Lights

    Good morning knowledge base. I have a project involving auto electrical (so 12V DC, or 13.8V on a good day) and LED lighting. I have a pair LED lights (total 60W) that I would like to be dimmable via a switch. The lights will therefore be fed by two circuits (one with a fixed resistor for the...
  7. T

    Auto hammer.

    Any experiences? Any use for nailing in cable clips in tight awkward spaces or overkill? Had a run on below entry/ceiling-less site work atm meaning much clipping. I'm talking of these kind of gizmos: HiKOKI NH18DSL/W4Z 18V Automatic Nailer Bare Unit -...
  8. T

    2009 holden cruze auto

    I purchased this car as a none runner , suspected starter motor issue. When I removed starter there was two cables connected to the ground , one I know is earth , the other has two wires connected to the one connection lug. Then there is a cable connected to the solennoid from alternator . The...
  9. A

    How to power up yard art with auto headlamps

    Years ago, I cut off the front end of my 1970 Pontiac Catalina before I drove it to the junkyard. I created a bracket and mounted it to my garage wall and successfully hooked up the four headlights and side marker lamps to a power supply that converted my 110 household AC current to the 12...
  10. E

    Auto Transformer Neutral

    I'm connecting three phase step down auto transformer. 400V input and 230V output. It's to supply a piece of equipment brought over from America and the load won't be balanced. My question is, is the star point common for both the line and load side neutral connections? I'm leaning towards yes...
  11. A

    Hello I am searching for work in germany, for auto electrical. Can someone suggested me a website to get work ?

    I live in Albania but I am searching for work in Germany . Because I cannot a find job in my country.
  12. S

    480v hand off auto switch help

    Hey everyone, Im new to this forum, but im looking for some info on wiring up some 480v light with a 480v contactor, a hand off auto switch, and a 480v photocell all tied in together. Having trouble getting the auto to work. Thanks
  13. S

    FAAC gates not auto closing. Broken wire

    Hi. I have a set of FAAC gates. They work on a master switch a sim card opening system where my phone opens the gates. Everything was working perfectly until last week when the gates opened and closed ok but when the photocell was tripped the gates wont close unless you dial the number or flick...
  14. I

    C-Tec Panel Auto Door Connection

    Evening all, Can anyone tell me if this panel has connections for a cable to signal an automatic sliding door to automatically open when the system has alarmed? Cant see to see any mention of it in the document below...
  15. C

    Auto electrics

    Hi Everyone. Just checking that auto electrics can be discussed and if so which forum should I use. Thanks.
  16. B

    Auto selecting DCDC charger input

    Hi guys, I have a strange situation where I am designing a system for my mother's motorhome. I want it so she doesn't have to change any wiring while on the road. I have a 12v LiFePO4 battery bank in parallel, and will connect it to a DCDC charger, which will connect to the alternator for...
  17. K

    HVAC, fan not ON working in AUTO mode

    I replaced an old (mercury type) thermostat with a new Honeywell thermostat model RTH2300B. The wiring is quite straight forward based on the manual: red to R, white to W, yellow to Y and green to G. There is no C so the 24VAC common is not connected. I have to install 2 AAA batteries per...
  18. J

    electrical leak auto off

    Hello, I am going to install garden spotlights. I know from experience that theses lights installed outdoor will develop leaks to the ground or even short circuits especially when wet. Is there a device I can install such that the power automatically switches off when leaks develop? Julian
  19. G

    Auto lighting issue

    Hi all, I would like to replace the standard 12 volt instrument lighting in my 1992 Toyota with a 12 volt led strip, is it possible to include a dimmer switch in the circuit ? many thanks. Gt4grey
  20. R

    Need help from an auto electrician

    Hi guys, I am currently in the Philippines and with all the Islands locked down it is very difficult to get a good vehicle electrician. I have a 2009 Nissan Navara D40 and my issue is the headlights dipped beam doesnt work. I haven't owned the truck that long so I dont know the history. Ok, so...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock