below

  1. B

    Spur socket below lightswitch

    Hi there - good site. Mrs wants a new socket directly below a light switch on the ground floor (says it will look neater vertically inline) spurred off the downstairs ring, which all go up into that above ceiling/below floor space. I gather I'm OK to do this as a (very experienced) DIYer? Or...
  2. J

    Could somebody please tell me what the name of the below circuit is please

    Hi all, does anybody know the name of this circuit and how it operates and the purpose of each component please? any help is much appreciated. Thanks in advance
  3. J

    Could somebody please tell me what the name of the below circuit is please

    Hi all, does anybody know the name of this circuit and how it operates and the purpose of each component please? any help is much appreciated. Thanks in advance
  4. J

    Wiring a bungalow..... from above or below?

    Looking for opinions on this guys.... I visited a rewire on a bungalow, classic build, a concrete floor slab with gap above then floorboards ( the gap is probably 45cm/18 inch) built in the 70's the original wiring is under the floor. (except for lighting obviously!) The electrician doing the...
  5. M

    has anyone came across the part below?

    Has anyone ever seen the above? Is this a fuse or coil or Tx? I need to find a replacement.Thanks
  6. Vortigern

    Ideas on fixing the below High bay

    So you can see the high bay model number and control gear with the LED array below. DC volts coming out of the control for 100w LED is putting out circa 50 V. Polarity is correct. There is continuity to the terminals on the array. No light from the LED. Any ideas of how to test the array or...
  7. S

    Earthing with solid rock below surface - burying tape for lightning earth

    A quick search for earth tape didn't come up with much, though this thread was of interest. I'll start by mentioning that I've led a sheltered life and only ever dealt with PME (TN-C-S) so never had to deal with earth rods. At our church, we've had an inspection of the lightning protection...
  8. NellyManjaro

    Consumer unit below main fuse

    Just a very quick one as can't find anything that answers my question Doing a re wire and a very old property the main incoming cables come in half way up the wall.... providing I don't run my circuit cables past them is there any reason I can't fit the consumer unit below the main fuse? I...
  9. H

    how would i calculate the approximate frequency of the sinewave? see parameters below

    so suppose i have a single-pole (first-order) low-pass RC filter that gives me a unity gain upto the corner frequency of 1536Hz and i apply a 12V amplitude sinewave to the input of the filter and i am getting a sinewave with the amplitude of 4.1V from the output of the filter
  10. M

    Advice: flat below me is being rewired by unqualified electrician.

    Hello, Some advice please as I think that the flat below mine is being rewired by someone who isn’t qualified. The small basement flat below mine sold a few months ago. I know the property was in a bad state and the wiring and electrics go back to the 1970s. The new owner is attempting to...
  11. T

    Install Shaver Point in Wall below Lintel

    I have to install a shaver point in the breeze blocks of an outside cavity wall, so would use a 47mm plaster box. The problem is that the only practical location is about two feet below the end of a window lintel (and about 4 or 5 inches in from the edge of the window recess (so under the end of...
  12. K

    USA Connection above or below terminal screw plate

    Does a wire attaching to a screw terminal on a standard receptacle outlet go over or under the little brass movable plate, please? Thanks
  13. F

    USA What brand is this panel?

    Can anyone identify the manufacturer of this panel? What type of breakers it takes? Slim breakers possible?
  14. N

    Which is the best earthing scheme suitable for worst/large value of soil resistivity in order to get earth resistance value below 5 ohm?

    i don't the exact value of the soil resistivity as no survey of soil sample is carried out at the site .However Copper earthing electrode 50mm diameter of 2.5 m is driven where its circumference were filled with chemical compound power to the height of rod and earth resistance was found to be...
  15. D

    Confused on question about PLC's see below

    so for my question i have been asked this: 1.Explain the terms “Bus” and “Star” as applied to a modern programmable controller system. 2. Describe, with the aid of diagrams, a network configuration that could be using to connect a programmable controller system. To do this task, select one...
  16. J

    Zs values and 50v

    Hi all I’m doing some work on my NVQ and came across this on the internet. Can someone explain this picture to me and if it is correct.
  17. L

    UK electrical helper looking for experience.

    Hello everyone , I have just completed a course that gives me the qualifications below: 18th edition wiring regs Portable appliance testing level 3 qcf Part P Domestic Installer Level 2 I have done some practical but not as much to call myself a sparky. I would like to know how to go...
  18. S

    Ceiling grid panels which drop below the ceiling grid

    I am replacing in ceiling grid lights with LED panels, but the metal tiles drop below the grid rather than inside it, so the LED panels will be semi-recessed I don't think the client is going to be happy about this so I was wondering if there is a light which drops below the grid by 10mm to keep...
  19. C

    Earth rod installation services below

    Hello guys I have a job coming up where i will be installing x2 car chargers in an office car park (wall pods) supplied from a PME. When installing earth rods what procedures can anyone recommend to ensure you do not go through any services below? Site drawings would be ideal however they are...
  20. FatAlan

    Getting across ceiling joists from below - tricks of the trade.

    In the day and age of ..how many downlights can we get into one house, I'm intrigued to know what tricks / techniques folks use to install multiple downlights into an existing ceiling in replacement of a central pendant. In particular, once having located the joists, how do you get the cables...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock