method

  1. C

    Best method to calculate 4 core SWA current rating for two pairs of 1PH line conductors

    Hi, I have a Victron Multiplus-II 5kVA inverter/charger with Pylontech US5000 batteries installed in my house along with a 6.8kWp PV array and associated charge controllers. This installation has full DNO G99 approval and was installed to BS7671 and has been running great for about 18 months...
  2. S

    Installation method?

    If cable is run through holes in joists, then turns through 90 degrees, clipped to the joist, then clipped to the brick wall as itvdrops to the socket, (protected by metal sheathing) is this fixing method C.
  3. Trevreg

    Correct earthing method for house?

    See attached photo of my new 3 phase supply at my house. Tails supply a Schneider 3ph board. Sparky is in two minds about the correct earthing method as the powergrid haven't supplied an earth. What's the correct method?
  4. A

    Installation reference method B

    Hi Guys Is there a reason why installation ref method B (in conduit or trunking on a wall) not listed as an allowed installation method on the maximum cable length charts (table 7.1)? Regards
  5. J

    How to terminate 20mm PVC conduit into a back box/socket - preferred method, whilst maintaing IP rating ?

    Hi All. What is the best/preferred method when connecting 20mm conduit to a back box of a socket on an outside wall ? I am connecting a BG Weatherproof Storm DP 13A socket to an outside wall, fed from socket directly behind the socket from the kitchen. Would using a 20mm female or male...
  6. B

    Reference Method E and F

    Hi All, Quick one - Ref Method E is multicore and F is single core? Thanks! Ben
  7. happysteve

    CCC 1.5mm T&E ref method B?

    Morning! Would someone please mind checking the big brown book for 1.5mm flat sheathed cable, ref method B, CCC? Page 456 from memory. Only have the blue book in the van, which lists refs A and C but not B. Voltage drop is ok, as is Zs. Thanks! :)
  8. Rockingit

    Preferred method for presenting galv conduit in/onto plastic accessories?

    I've an otherwise small and simple job to do later, out of hours, fit an outdoor IP FSU for a small AC unit fed from an outdoor socket on an RFC, all external wall. However, because it's at an animal hospital and located where dogs get exercised I'm taking a cautious approach and doing it in...
  9. Bobby34

    Kitchen Grid switch method

    Hi everybody, Looking at putting a kitchen grid switch in my kitchen and wanted to see what you guys (and girls) thoughts were about my set up as i've not installed one before. Looking at running a 2.5mm radial just for the sockets and a boiling tap (1500w) theres no large appliances to be...
  10. S

    Reference method 100/102 or A

    Hi everyone. What's the correct reference method for cables (2.5mm t&e 32A? ring main) clipped to wooden joists between the ground floor and first floor. Standard build plasterboard ceiling, chipboard first floor. The joists are to be filled with loft type glass mineral wool insulation. Joists...
  11. telectrix

    what reference method?

    T/E clipped direct to brick. however, kingspan backed board is to be fitted so insulation direct onto cable. my thoughts are 102 as cable is touching wall, but not the inner board as described in BS7671.
  12. Mr_WD40

    Best method for oversized gauge?

    Morning all. I wasn't too sure how to phrase the title for the issue I have. So to explain and hopefully there will be a simple solution. I have a single recessed patress socket with three wires into each screw down terminal. I wish to swap this for a single to four gang conversion socket...
  13. C

    Safety of Using Adiabatic Method?

    I'm thinking, and while I could be wrong, is the adiabatic method a possible latent safety hazard? As well as undersized CPCs on circuits 32 amps and under? Normally DNO sources are strong with relatively high PFC, and we have a known Ze value. However, should someone bring a portable...
  14. newfutile

    Method of perceived electric shock?

    If we assume our feet are insulated from the ground why do we get a tingle if touching a live wire?
  15. C

    Wall switching method for 12v adapter powered devices?

    I'm not a pro, just looking at strategy for a village hall install. In the bar area, there are a number of devices which need to be switched on in one go. Some LED lights, a video monitor, wifi externder, other low power stuff. They are the type with the plug in 13A to low volt wall adapters...
  16. U

    Best Method for Splicing into a Radial Power Circuit?

    Hi everyone, looking for a bit of advice on extending an existing radial circuit in my home (England, UK). I'm fairly experienced with basic electrical works, and regularly convert homes to 'smart homes', however the following has me stumped. The house was rewired 5-6 years ago, prior to my...
  17. Rockingit

    What reference method?

    Got an install that doesn't quite fit any of the tabled methods... more than 3 SWA's laid in 6 x 6 galv conduit, inset in screed / concrete, with lid. Ref 70 applies to ground (soil) and 118/119/120 is direct to concrete which has different thermal propogation than the galv that they're...
  18. E

    Are there any resources that show an actual job being done for trainees

    Just looking for resources, books and videos ideally, that show how to actually do the physical job. ie you need to wire some lights in, what's the best method to bring the feed in to the lights, or you need to put sockets in, what's the most efficient way to do the job ie chase out first, put...
  19. J

    Reference method

    T&E cable run in a stud wall without insulation, would this just be clipped direct? Ref method C? Cheers
  20. K

    Which method you use to install spotlight with no access above ceiling ?

    Which method you use to install spotlight with no access above ceiling ? Do you make holes under joist and fish wires and then later how do you fill them? or how do you overcome this and at the same time try to respect regs?

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock