mixer

Recent contents Top users
  1. P

    Short circuiting dough mixer

    Hi, I’ve got a brand new dough mixer which won’t work. Out of the box it just popped when switched on and tripped the power in my shop. Using a voltage pen I’ve detected that there’s power getting into the circuit board but not out. Noticed the fuse in the board was gone so replaced it and when...
  2. G

    Does a Digital Shower Mixer Valve require an RCD ?

    Im considering installing a Digital Shower (not pumped, just controlled) during my Bathroom Refit. Im looking for the best option for powering the valve. The Manufacturer recommends runnig a 30mA RCD circuit, however as my Sockets are already protected with an RCD can I connect the valve into a...
  3. B

    Industrial Dough Mixer (Kemper SP125)

    Hello, I am a baker and an apple juice producer. I built my own apple juice pasteurising factory and associated electrical controls, I maintain my own equipment and have my work checked by our electrician before allowing any employees to touch it! I am reasonably competent but I am not an...
  4. T

    Running a heavy duty food mixer with adapter

    I need to buy a larger mixer for my small bakery, but I only have standard wall outlets and an oven outlet (pictured); the mixer has a NEMA 6-20 plug. Can I safely run a mixer with the ratings indicated in the attached spec sheet using an adapter to either the normal wall outlet or the oven...
  5. Z

    kenwood mixer chef km210 does not work

    I have Kenwood chef mixer' and the problem is mixer dead noting, not working after some steps to check, I'm suspect that the electronic control board seems bad I checked all components and find them good but the board, not function and I do not understand how it works please your Advice att...
  6. K

    Shower digital mixer valve compatibility with regular fittings

    I have a pretty basic question on suitability of a shower digital mixer valve. Checked with the the manufacturer Mira, who insisted that it should only be used with their shower heads, etc. Asked why, looked around, etc but can't seem to find a clear answer why. Basically I have read the manual...
  7. S

    IPX4 or 5 needed for extractor over bath with shower mixer tap?

    Hi all. I need to fit an extractor fan on the wall above my bath. The bath has a shower mixer tap, but due to the slope of the roof this will not be used for showering but to rinse hair etc in bath - the shower handset clip is mounted just above the bath - photo attached. I'm unsure about the...
  8. G

    mixer value on underfloor heating?

    HI all, installed a s plan, well i say s plan, heating up stairs and underfloor down, there is a 3 way manifold for the underfloor heating, a couple of question regarding that pls 1 actuator came , but there is a value i open with that stat so i assume i dont need the actuator ?? also i...
  9. Marvo

    Mixer

    Has anyone ever stripped a planetary type mixer before. I bought a cheap 2nd hand one on gumtree this afternoon that's has a 3-speed gearbox and 1 of the speeds isn't working. I've never touched one of these things before and just wondered if anyone might work on this type of equipment and have...
  10. R

    PAT Test MInibelle mixer?!

    Hi All I have recently qualified as a PAT tester, for doing in house stuff for a building company. Does anyone know how to PAT test a cement mixer with a magnetic start? I was told on my training course that you could buy an adaptor for such purposes but I have drawn to a blank where to get...
  11. D

    Dj karaoke mixer

    Hi i have a karaoke dj mixer and the switch that you change the power from 100w 300w 500w is faulty? The sound is fine out of the left channel on all 3 settings but on the right channel when you move it from 100w to 300w you loose 90 per cent volume and if you wiggle it a bit it comes back on...
    • DJDAVE
    • Thread
    • aus mixer
    • Replies: 8
    • Forum: Australia
  12. T

    Wiring non-powered basic line-level mixer

    Hey guys, this is my first post and im only 15 so be nice xD a while ago i got my hands on a basic powered mixer that had blown up and was beyond repair, so i wanted to convert it into a passive mixer without buying loads of extra bits and bobs, im not sure if i can do this though. inputs and...
    • tomhop
    • Thread
    • aus basic mixer wiring
    • Replies: 4
    • Forum: Australia

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock