i am trying to install a 1no1nc push on off led switch in my car to intercept my power antennae. it has 5 terminals with red, white, black and 2 green wires. the 2 green wires are marked NO and NC. i think the red is marked+. cannot see any markings for black and white wires.it did not come...
Hi iv just fitted a cooker hob to a newly fitted kitchen, the junction box for the hob and oven was already there and the cooker switch too, in other words it was all there and ready to go it just needed a heat resistant flex for the hob, however when i lifted the panel over the terminals to...
irrelevant name
Thread
cooker
cooker hob
fitted
hob
installation
needed
other
phase
question
We have two switches to our main light fitting which has 4 spotlights. Both switches have others that service other rooms and they work ok. Other lights in the room work ok. Connections in the fitting are fine and nothing tripped on the fuse board. Any thoughts from anyone out there very much...
jonesy76
Thread
fitting
light
other
problem
switch
switches
working
I've got a lighting circuit wired in 1.5mm T&E on a 6 amp MCB. There are some lights that I'd like to add on to this circuit, controlled by an existing switch. Due to the position of these lights, the most aesthetically pleasing way to install these lights would be to run cable to the new lights...
Hi Everyone
I am extremely stuck.
I have got an old plastic switch that I am replacing to a polished one but I have come across a difficulty after I have changed them over.
The switch is for the kitchen lights.
I currently have one Tube light connected to them and on 3 switches there are...
yusufg
Thread
changes
connected
light
light switch
lights
other
switch
Hi folks, what is the score now with HSE etc and storage batteries on a solar installation? I know banks of storage batteries were a big no-no a while back, I help out with a wildlife charity who have a completely off grid solar set up with approximately 1500ah of battery power @24volts, I'm...
I had not used my B&D mini vacuum for a while, went to recharge it but the charger gave no output. Stupidly without checking the price of a new mini vac like the Vax Gator, I bought a new B&D charger but the battery would not recharge. Consequently, for future information I wondered if there...
electricans_son
Thread
battery
charger
check
checking
other
possible
without
Meterl Instaltest multifunction test meter , Metrel PAT test meter and other items for sale as I have just retired - see my Gumtree listings :
https://www.gumtree.com/sellerads/1156727929?page=1
all collection only, Durham area
Thanks for looking,
Andy
andart
Thread
equipment
for sale
interested
message
meter
meters
other
sale
test
Hi all
hope someone can aid me in this issue I've got
why would a tx give out more output voltage on DC side
than stated 30-42v Dc ( getting 57vdc)
we have swopped tx over to other led on different circuit
and all is ok 38v dc lights work
put the other tx back which works in office onto...
Hi,
Just wandering what to use to get an armoured through a new duct which has been installed prior to me being on site without a pull rope.
Longest run is about 30 meters with probably 2 bends and is about 3 inch diameter but is the flexible type with ridges.
Will rods go that far and round...
Hey everyone. Bit of a silly noob question.
On my dirt bike, as I was tightening the positive battery terminal lead(it was loose), the allen key slipped and hit against the subframe causing a short and sparks everywhere, and causing the allen key to be extremely hot to touch.
It was only for a...
peteandrewd
Thread
battery
components
connected
damage
other
out
positive
short
terminal
I have noticed that the EPC figures for a 2.5kw system for the solar savings is extremely higher than any other method for working out the savings.
Anyone else noticed this and surely this is extremely misleading?
RECC figure is nearly half of this for SAVINGS alone.
regards
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.