overhead

  1. B

    Overhead cables between buildings on domestic property

    Hi all. I've recently bought a bungalow. It currently has a armoured cable between the house and garage which spans less than 1 meter. The height of the cable is 2.3m and directly under this is the side gate to access the back of the property. It's old wiring so will be replaced, but I've had...
  2. ThomasB

    Overhead triplex feeder termination question

    I have 6-6-6 triplex overhead that I'm running to a detached garage. At the weatherhead at the garage I'm going to splice 8 guage thhn copper to run down to the sub panel (approx 5' max of 8 guage at both ends of the run). This feeder will be on a 50a breaker. Does anyone see any issues with...
  3. C

    short overhead cable height - house to garage

    I'm in the process of installing Catenary Cables to support 2x SWA and 2x cat5e cables, over a distance of a small distance of 1.5m. The cable entry hole at the garage is 2.30m high and the house cable exit hole is just under 3.0m high. Below the supported cable is the garden gate/door and...
  4. Kweshaz

    Working on 11kv overhead line

    What are the requirements in terms of safety before work is done on a private overhead line be it repairs or deviation of line.
  5. T

    Overhead bed lighting for reading.

    Hi all, This is my first post. The other night It was noticed that one of the lights started to flicker. Both bulbs were changed the next day and the one that flickered still flickered. A further investigation showed that a RELCO MICRO 60 PFS ELECTRONIC TRANSFORMER had been fitted. To buy a...
  6. M

    Canada Does anyone have a copy of the C22.3 N0 1-15 Overhead system?

    Looking for a PDF copy of the C22.3 No 1-15 Overhead systems Code. Just need it for test and dont want to have to buy it to never use again..
  7. J

    Overhead crane

    Hello, anyone know why an overhead crane would cut out. It only cuts out when it gets to a certain point in the building. I have IR,continuity test on from control buttons to main panel. Tested windings of the motor all ok. Checked the busbar channel to ensure connectors have not worn down. 7...
  8. J

    Camélia a Mechanical calculation software download link

    Hello, I would like to download Camélia a Mechanical calculation software for overhead distribution lines. can someone have it's installation or link ??
  9. M

    DNO UK power networks changed incoming overhead and now have PME TN-C-S but ccu connection to TT

    Hi all. I'm currently training as an electrician so would like your views on this for clarity and if I need to get someone in? I have just moved in to a new (very old) house and on inspection of the CCU I noticed the incoming service cable from the overhead was chard at the top of the dno head...
  10. P

    Overhead to granny flat? Would I need a specialist?

    A granny flat will be at the bottom of a long narrow garden - 50m from supply at front of main house out to the new building. The granny flat is very near to a supply pole but I have been told that only one connection can be made to any one property. This leaves me two options - overhead (30...
  11. J

    IMMIGRATE (uk->nz)

    Hi there folks, names Jimmy, new to the forum. Am just after any advice anybody has or any contacts anybody has regarding resettlement in NZ from UK on the overhead distribution networks. My self and my family have discussed about immigrating to New Zealand for some time now and it’s time to...
  12. A

    UK overhead cable height

    Can anyone please tell me what the minimum height for an overhead cable from my house to my shed. The gap a 3ft and it is wired from the main fuse box and into another fuse box in the shed. It is encased in conduit and at the lowest point is around 7ft (this then enters the shed)
  13. T

    Homework - low voltage side 3x400V and a short-circuit power on the low voltage side 95MVA is powered by an OPS

    Hello everyone please help me with this homework which is too hard for me due to the fact my teacher didnt teach well so i have some problems with this schoolwork. a distribution transformer station with a voltage on the low voltage side 3x400V and a short-circuit power on the low voltage side...
  14. D

    Safety painting around overhead cables

    I need to paint the house woodwork. I have an overhead power supply which is attached to the corner of the house tied (I really hope) into the wall though the fascia and gable barge board. I think the supply cable probably dates from the 1980’s. So can I ask for any advice on how to paint...
  15. C

    Overhead property supply clearance requirements

    Hi, we have a single phase overhead supply to our property, and are constructing a garage with a corner near the center of the ~15m span. What is the minimum separation to the structure? Is it possible to secure the cable at the midway point on the new structure? Thanks!
  16. N

    Advice please- changing from overhead lines to installer

    Due to a change in my circumstances I want to requalify as a domestic installer and don’t know if it’s worth paying to do a crammer course (installation and test, part p and 18th edition) in a hope to get a electricians mate or trainee electrician job so I can learn the ropes and get properly...
  17. Michael J

    Three Phase overhead supply is it TN C

    While carrying out a EICR I found on first inspection that there were no RCDs installed . When I checked at the Pole Mounted Transformer the Earth & Neutral were connected at the Neutral point. So am I right in concluding it's a TN-C System? The 17th Edition states that RCDs should not be...
  18. O

    de Havilland Mosquito - l would love to see and hear one of these overhead

    Just been reading about this.................. https://www.justgiving.com/campaigns/charity/thepeoplesmosquito/take-off Wouldn't that be great!
  19. R

    Interview help/information needed on an overhead linesman post

    Hi I've recently got an interview to become a linesman in northern ireland, would anyone be able to provide me with any interview tips/skills or even any extra knowledge of the trade would be helpful. Thanks.
  20. J

    overhead incoming supply TT TNCS?

    Looked at a rewire for a 5bed house reno this morning bit of a odd setup! so the house is supplied overhead- see pic 1- 2cores through the roof in loft into a 60a fuse then what looks like a 16mm T+E- but cpc (if one) is not used this travels some meters (at a guess 10m) down to the ground...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock