Posting a message to the forum will remove the above advertisement

This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
While you're here, would you mind checking out our Electrician's Insurance section to see if we could save you a few quid? - Specifically our Van Insurance Deals and Public Liability Insurance Deals. Thanks for supporting the forum!

5% Discount from Electrical2Go.co.uk for ALL members! - Click Here

rover

Showing results 1 to 4 of 4

- Tiles de-bonding from new house posted by Tileadvice. Hi there. Has any seen an issue with tiles that de_bonded or became loose? We moved into a new build. Floor base was not powerfloated (which is better for tiling). Tiler used Larsen Primer,...
- Why Not Say Good Morning Before Work? posted by antonio. why not say good morning before work? We start Monday? tomorrow x workers :)
- Wanting a trimless finish with bullnose tiles but not possible due to cut edge in metro pattern? posted by mofonyx. Hi, Our bathroom is being renovated. I wish not to have a trim and went with a range of premium tiles that offered a short rounded edge (bullnose) tiles (cut out page in catalogue here......
- Gas Landlords Certificate posted by Dan90. Evening All, I need advise and guidance to set up a small business. I want to start with doing Gas Safe inspection, for myself. My experience and knowledge, I done colleges courses Gas techincal...
- Inline pipe valve/taps dripping after turning off and back on posted by Gary555. I’ve recently moved into an old house and I’ve just replaced the immersion heater in a copper cylinder. The problem is that, to stop the tank from refilling I turned off two pipe valves (not...
- Hello DIYer here in a new (but old) property posted by Gary555. Hello, I’m your general run of the mill DIYer, I’ll have a go at most things with good instruction. I’ve just moved into an old property and I’ve encountered a problem already. I’ll post in...