terminal

Recent contents Top users
  1. GBDamo

    Terminal corrosion on AC compressors.

    Been doing some maintenance/service work on AC compressors and one thing that concerns me is the amount of heat at all the various terminals along the start and run circuit. In brief the the current draw should be anything from ten to twenty amps but I'm often seeing readings 50% higher that...
  2. H

    Can you extend ring cabling with terminal strip inside socket back box?

    My boiler is currently plugged into a double 13A socket in my utility room. I want to move this connection to an FCU and add an extra double socket. As a general rule, I try to incorporate additional sockets and FCUs into the ring rather than via spurs, but the cabling that feeds the existing...
  3. D

    Metal Light Switch + Plastic Back Box with no earth terminal

    I've tried to find a solution on here to this exact scenario but had no such luck. Could somebody please advise on where I should place the earth wire on a plastic back box with no earth terminal when adding a new metal face plate? The face plate has an earth terminal on it and was probably...
  4. T

    Clear stuff exuding from neutral terminal on Immersion element

    Hi, got this request to look at immersion heater. Customer says there was a burning plastic smell coming from immersion element head, he looked and saw clear "stuff" coming from the blue terminal. I asked if the cable looked burnt and he said no. So I was thinking of going with some butyl and...
    • The Ghost
    • Thread
    • clear coming element immersion neutral stuff terminal
    • Replies: 10
    • Forum: UK Electrical Forum
  5. L

    Confirmation of Hive Wiring

    Just swapped a Danfoss RX1 for a Hive v2. I initially thought I would just put the wiring into the same place, easy enough. Didn't work. I notice the terminal allocation is different between the two: Danfoss: N - L - 1 (unused) - 2 (COM) - 3 (ON) - 4 (OFF) Hive: N - L - 1 (COM) - 2 (OFF) - 3...
  6. B

    Help With Basic Light Wiring

    An old small tubular striplight in a desk/cubby hole in my aged parents' house has gone and it seemed silly to call out an electrician for one small light so I said I would help. Obviously, I thought it was just the bulb but tried the bulb from the bedroom next door, which has exactly the same...
    • Barns
    • Thread
    • basic earth fitting help light terminal wires wiring
    • Replies: 9
    • Forum: DIY Electrical Advice
  7. sajeel

    Earthing System Advice

    Hi Saw a mates job the other day where the supply is three phase, however there was two earthing system at head there was tn c s and tn s. So there was separate earth clamped on supply wire to main earth terminal and a additional earth wire run which was connected to neutral of supply ? Didn't...
  8. Leesparkykent

    Texecom premier elite compatibility

    Doing an unoccupied rewire on a house for a builder and part of that was running the cables in for a intruder alarm. finished of the snagging today and the customer has asked if I would mind fitting the alarm as they've been let down by the person who was supposed to do it. I had a look at the...
  9. Mark.W

    Earthing Faceplate

    Hey Guys, I'm in a discussion with another spark about whether or not he earths the metal back box of a floor socket box. He seems to think there's no need because the faceplate gets self drilled to the back box and it doesn't have lugs like a standard metal Patress?! The faceplate screws...
  10. D

    Installing Nest 3

    Can anyone advise on the right way to replace the danfoss tp9000 thermostat and ts2 sensor with the nest. I have attached pictures showing the current setup. Thanks in advance,
    • Deepu Thomas
    • Thread
    • attach earth installing nest neutral programmer terminal
    • Replies: 2
    • Forum: Central Heating Systems
  11. charlie76

    Light Switch Back Boxes with no earth terminal

    I am working in a property that has the old steel painted switch back boxes that have no earth terminal. Came to light when testing R2 on the switch faceplate screws and got open circuit reading. Earth is present but just sleeved and folded over in the back box. I intend to ring crimp the earth...
    • charlie76
    • Thread
    • boxes earth fixing light light switch no earth screws switch terminal under
    • Replies: 13
    • Forum: UK Electrical Forum
  12. W

    3 lights off one lighting spur? any issues

    have this arrangement in loft: 3 lights going to a 3 gang switch, each live going to each L1 terminal, neutrals connected together in wago block, each com terminal linked with small link cable. supply comes from junction box which is spurred off lighting circuit, live from supply goes to com...
  13. H

    Terminal Box Wiring Coming Through Wall for Conduit

    hi is there a steel terminal box that caters for wires coming from inside to outside, all the terminal boxes i've found don't have holes at the back. i was just wondering what would be the correct way to feed a wire through the wall into a terminal box (then through conduit to a camera outside)...
    • h901
    • Thread
    • box coming conduit drill outlet terminal through wall wiring
    • Replies: 38
    • Forum: UK Electrical Forum
  14. D

    Terminal terminology!

    I am trying to replace some thermostats on a ceiling heating system, I think they are Honeywell T6060 units. The terminals are designated as 20(4)A @ 240v. I assume this means they are good for 20A load, BUT what does the (4) mean?? Any suggestions for modern replacement units that can carry...
    • David Galvin
    • Thread
    • ceiling heating rating system terminal
    • Replies: 8
    • Forum: UK Electrical Forum
  15. A

    Bypassing a PIR sensor

    I have a 500W Security light with a built-in PIR sensor. See: https://www.amazon.co.uk/gp/product/B005OB0MVW/ It works fine, but if I'm outside at night I have to move within range every few minutes to keep it on. So what I want to do is fit a switch to bypass the PIR. The four-way terminal...
    • Al-42
    • Thread
    • attach light pir search sensor switch terminal
    • Replies: 8
    • Forum: Lighting Forum
  16. F

    Help wiring ceiling fan. Amateur!

    Hi Chaps. I am putting in a ceiling fan. My electric skills are basic. I have 3 sets of wires in my ceiling. 3 lives, 3 neutrals (one is the switched live) 3 earths. The fan has 2 lives, 1 neutral and 1 earth. The fan has a 3 hole terminal block. I will be using the wall switch to turn the fan...
    • fredo
    • Thread
    • ceiling fan light terminal together wiring
    • Replies: 26
    • Forum: UK Electrical Forum
  17. B

    63amp commando plug pilot terminal

    what's the pilot terminal for?
  18. M

    Y plan with additional two port valve

    Unvented y plan system with additional 2 port valve overheat protection. I'm trying to find a wiring diagram for this set up. Has anyone got one please?
    • midgetman
    • Thread
    • additional attach boiler diagram terminal valve wiring y plan
    • Replies: 1
    • Forum: Central Heating Systems
  19. G

    Help needed re-wiring my garage

    hi The electrics in my garage are a complete mess. So I've taken everything out and started to renew everything . I have installed a garage consumer unit . I have managed to install the armoured cable . I am now stuck at lights . I have taken a feed from the cu to a fluorescent light and a...
    • Gary Holmes
    • Thread
    • attach fluorescent garage light needed switch terminal
    • Replies: 61
    • Forum: UK Electrical Forum
  20. S

    How do I Wire Main combi Eco 25 and HIVE 2 single channel receiver.

    Hello I have a Main combi Eco 25 (without timer) I would like some advice to connect it to my HIVE single channel receiver. I have included I photo of the boilers wiring diagram. My hive receiver is single channel and has these conections. N L 1 Common 2 Heating off 3 Heating on 4 (unused)...
    • scott T
    • Thread
    • boiler channel combi connect earth heating hive main receiver single terminal wire
    • Replies: 8
    • Forum: Central Heating Systems

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock