tripped

  1. C

    RCD Tripped More Than Once In a Single Evening

    My RCD tripped more than once in a single evening. When I went into my kitchen to investigate my appliances I noticed that my washing machine was left on (in pause mode). Does anyone think the cause of the tripping could be the washing machine (especially when left turned on)?
  2. M

    Tripped Socket - 50v

    Hi, New to the forum and I've got an issue in my house. I''mnot an electrician. Our main RCD tripped last night and after investigating I've found the cause to be one of the sockets in the living room. Testing the socket shows 50v across L+N, 230v across L+E, 30V across N+E. Am I right in...
  3. C

    Water on hob- tripped RCD- how to fix?

    First of all, apologies if this doesn’t make sense- I will try and explain as best as I can. A pot boiled over on the hob and quite a bit of water was laying on hob. I wiped it up and turned of gas. However this appeared to trip the RCD. The only way I could reset the RCD was by turning the...
  4. P

    Ring main tripped struggling to find cause

    32amp ring main tripped mcb and rcd overnight. Rcd will reset but not all the time, mcb will not reset. Unplugged everything in house and mcb still trips, but rcd ok now. 32amp ring main covers whole house and struggling to locate fault. I'm newly qualified and probably missing something obvious...
  5. cliffed

    No thanks

    Called out to a house where rcd is tripping,been going off over a period of weeks. Did insulation test,got pretty good readings overall,except one circuit,which gave me a L/E,N/E reading of 0.40 meg ohms. This was a sub main to a garage,found lighting to be at fault,disconnected. Re did test...
  6. J

    Mains smoke alarms

    Evening, I've just been asked to install some mains powered smoke alarms to a customers property, can I still add these to an existing lighting circuit (if the alarms have a battery back up) or do I need a dedicated RCD Controlled circuit from the CU?
  7. B

    What's going on there !!! everything tripped...

    Doing some redecorating and as part of that I decided to move a ceiling light about 1ft from where it was. I turned the light on, went to the circuit breaker, flipped the switch and the light went out, so I figured the light must be on that circuit, so far so good (I thought}. I took the light...
  8. A

    does this RCD need replacing

    hi everyone a second opinion would be appreciated was called to a house in February as RCD was intermittently tripping. some times 3 times a day sometimes none. during my initial look i discovered when the oven was ran for more then 5 minutes the RCD tripped. my inspection then found a...
  9. D

    All three RCD's tripped

    Good evening every body. Im new here so hello to one and all I have a question. I plugged my new 1710 Megger into a TSO in a garage with a two way board on a 30ma RCD. I did an RCD check and my X1 took the RCD out in the garage and the board in the workshop and the main house one too.. I...
  10. M

    Lighting circuit issue

    Hi guys, just after some advice. Went to a job today with the description that one rcd on a dual board has tripped and when closed trips instantly, the customer was watching TV at night and all of a sudden the lights and sockets went under normal running conditions. I arrived today and the rcd...
  11. M

    230v neutral to earth ? row of lights gone out mcb not tripped

    Hello all, I have recently attended a job where a row of lights have gone out and was advised and seen for myself when i got there that no breakers have tripped. First i took the cover off of the panel with the mcb's that feed all lighting circuits in open office area , and checked i have...
  12. S

    Ring Main fault

    Had a call this Morning that her rcd keeps tripping. So i went round there First of all unplugged everything still tripping. Done a few tests L-E N-E L-N and end to end test all came back as 0 mohms. So i Separated the legs at both the board and the sockets found the fault leg. Reconnected...
  13. V

    NICEIC Certification Scheme Niceic cert

    Hi all i have been filling in NICEIC certs now for the past two months the way our firm work is to give out what they call a site sheet we test and fill in the results and all the information and then the QS looks over it and finalises it, I was given a completed cert fully printed out from our...
  14. J

    How to troubleshooting the Circuit breaker protect 3 phase motor tripped?

    How should i do when the circuit breaker protect 3 phase motor has been tripped? step 1: how do i do...and then check...?

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock