whole

Recent contents Top users
  1. gergex

    Losing power to whole house, not tripping circuit breaker?

    Hi, recently moved into 30 year old home. We were renovating it for a few months and didn't notice this issue. 3-4 times over last month the power has gone out to the entire home, without flipping any circuits. When we've been home for it (twice) it has only lasted a few seconds. I'm yet to ask...
    • gergex
    • Thread
    • ausie elec breaker circuit circuit breaker house power tripping whole
    • Replies: 3
    • Forum: Australia
  2. B

    Whole Kitchen wiring diagram advice (excluding lights)

    Hi everyone, please advice and comment on the attached wiring diagram for a kitchen. There are mixed opinions on the need for FSU-s and number of circuits required. Distance to cu – 8m running under timber floor. kitchen size – 3.5M X 2.5M
  3. S

    PEN Fault Detection on Whole Install?

    Hi All, I understand the requirement for PEN fault detection on EV chargers for TN-C-S installs (or to place an earth rod). However, when I was looking for something else entirely I came across this single-phase 100A PEN fault detector. What would be the use case for this? Would you ever need...
  4. J

    Whole house rewire questions

    Hello, I am renovating a house. I am rewiring myself. I am getting an electrician to install a new consumer unit & test all my work. I'm looking for a sanity check before I run all the cables. I want to do first fix and get the house plastered. Some of the cable colours in the diagrams are...
  5. B

    Led lights on dimmers are flickering in whole house

    I have the typical LED on Dimmer switch. All the lights flicker in my house are very inconsistent times. By let me clarify by saying all the lights:):) Every LED that is in a dimmer switch all flash at the same time, same everything (time, consistency, rhythm). Here are the facts. 1.) One...
  6. J

    Whole House Backup Generator Install

    Getting ready to install a 22KW Generac on my home and just had a question to clear up. I have 400A service running to two 200A main panels. I will be installing two 200A transfer switches, mainly because I had 1 already and the 400A is like $2900.00 vs $700.00 for another 200A one. I know that...
  7. Qwe7410

    How to keep power trips isolated and not trip the whole place when testing faulty appliances?

    Having some 1400W 230V heaters to test and repair that have a power trip problem. I've unplugged all the connections and open them up one by one to identify the part that is causing the trips. Everytime it trips, it trips the whole place through the main circuit breaker. How can I do it safely...
    • Qwe7410
    • Thread
    • appliance appliances faulty isolate isolated place power testing trip trips whole
    • Replies: 2
    • Forum: DIY Electrical Advice
  8. Stamps44

    Replace rcd without replacing whole CU?

    Hi, could I ask for a second opinion please? My RCD failed routine 6 monthly testing using the test button. I'd like to get it replaced, and spoke to an electrician who said that he couldn't replace it without replacing the whole consumer unit because it didn't meet the the latest regs. It...
  9. W

    RCD for whole install tripping

    Hi, thought I’d ask in here and hopefully someone with more fruit finding experience than me can help. Customer saying Rcd tripping and they believe it was the sockets, as the socket mcb tripped once when it happened. Now I had unplugged everything that I could see, couldn’t see anything else at...
  10. T

    Kasa RGBIC slightly flickering... but not the whole strip... cut and extended...

    I didn't realize that RGBIC cannot be "cut and extended". Either way, with my soldering experience and very clean soldering job, the strip works but I have slight flickering. more so on some colors than on other colors and the only parts flickering are on the cut and extended part. I cut it in...
  11. N

    When working on circuits do you isolate whole board or just the final circuits using MCBs ?

    When working on circuits do you isolate whole board or just the final circuits using MCBs ? Or is there any instances when the whole board has to be isolated even if you are working on few final circuits? Thanks.
  12. B

    Periodic flickering throughout the whole house?

    Hi folks - new to the forums here. Forgive me if this isn't the right place to post. We have a small home, just moved in and noticing that 24 hours a day, once about every minute, ALL the lights in the house flicker at a pretty fast rate for about 10-15 seconds. It repeats this cycle 24 hours...
  13. B

    UK Insulation resistance whole board.

    Hi all. Changing a CU in an ex-council flat, pme system, no RCD's, and initially tried to IR test whole board L/N joined to earth, got a reading of 0.28 Ohms. Then did each circuit individually (2 X RFC, 2 X lights, 1 X cooker), L/N joined to the circuit's CPC, and got between 0.25 and 0.30...
  14. Natosha Jacobs

    looking for whole house lighting designs

    I’m looking for some whole house transitional or contemporary lighting fixtures to replace my ugly builder lights. All the ones I can see are either too cheap or for smaller places. If I look at larger home real estate listings to get ideas, they all seem done up in a traditional and showy...
  15. HappyHippyDad

    No power to whole house after water fell on to cooker???

    A friend has just called as his daughter in Belfast (many, many, many miles from me!) has just lost all power after water fell into the cooker/hob. I straight away thought it has to be a main RCD somewhere, but I cannot see one in the pictures they have sent and they don't 'think' there is one...
  16. OnlQQker

    Puts A Whole New Meaning To Working Live...

    Has anyone ever done any lineman work? Sudden weather change must be a nightmare!
  17. J

    whole house fan wiring to switch

    I recently installed a whole house fan (Master Flow # WHFS24M) as well as a thermostat to control it (Master Flow #PT6). I also wired it to a switch to be able to cut power to it as well. The switch is a dual rocker 3-way switch. I've broken off the terminal fin to effectively make it 2...
  18. Jordansenior

    UK One light working in the whole house

    Hi, I tried to put a dimmer switch in. There was a little crackling and the light was flickering. I put the old light fighting back on and now the light I was working on is the only one that works in the whole house. I have checked the fuse box and all the other electric things are working...
  19. J

    4293 elcb coding __________

    Been called to a job for a second opinion, Previous spark said current db set up would warrant a code 2 and therefore need a board change. Granted the elcb set up isn't great for discrimination but cant see this warranting more than a C3. But what about the elcb itself? It Tests out fine. Any...
  20. Jay 1987

    Looking for mentor/supervisor for whole house rewire in Birmingham

    Hello everyone My name is jay and I’m from the trainee section of this website. I have spoken to respected memebers from this forum and have been advised to create and send this message. Please don’t bite my head off or give silly non sensical answers, as I may get things wrong . (Thanks in...
    • Jay 1987
    • Thread
    • am2 birmingham electric house level2 looking mates mentor retired rewire sparky trainee whole
    • Replies: 14
    • Forum: UK Electrical Forum

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock