Hi all,
Just wondering whether it is better to put two wires into one crimp or use two crimps with one wire in each?
The crimps in question here are ring crimps and the cable is flexible(fine stranded) 1.5mm2. If I put both of the wires into one crimp I would use the blue ring crimp but if one...
Hi all
Would really appreciate some advice as my first attempt at changing a light fitting. Watched numerous YouTube vids but nothing quite fits what I am facing.
I assume I have pre-2004 IEE wiring, but a bit thrown by the blue and brown wires (see pic)? Also, not entirely sure which is the...
So I received my Wayfair light today - it’s a six light semi flush ceiling light.
I fitted it however only 4 out of the 6 bulbs lit up (all bulbs rotated and all work so not bad bulbs).
the wiring in the ceiling is a standard end of line 3 wires - live/ neutral/ earth.
the light has 4...
Hey holly electricians, I am asking are live and neutral wires different in composition or same but just some different colors of insulation. Was one type of wire just designed to carry electricity and the other to be a neutral one.? Are they different in composition? For testing purposes if I...
I have 200amp connection, with the meter and service disconnect at the road (see pictures). House panel is about 75 feet from the service disconnect at the road.
1) Assuming I need 4/0-4/0-4/0-2/0 AL wire sizes (considered a sub panel), exactly what type of wires are required to run from the...
Hi, need help re PIR switch wiring. The switch has 4 terminals L from distribution, N from distribution, another N to load (marked with red arrow in attached image) and L' to load.
My question is - can I leave the 2nd N (red arrow) terminal empty (not wired) given that the load (light) has a...
I have an electrical box on my kitchen wall that I'd like to get rid of.
Can I tape the wires up (separately), push them back in the box, and spackle over it, or is that prohibited as is the case of a conventional 110/120v electrical box?
I may leave some baseboard-mounted telephone...
My house was built in the early 90's and the builder, rather than installing bathroom fans, wired the air exchanger unit to all of three of the bathrooms and installed local mechanical timers to turn the unit on. Works OK, would have put fans in myself, but anyway...
So now as I renovate one of...
Hello first post
I inherited a secondhand freestanding Belling Oven (make and model below)
BEL FSE 60 MF
Model Number 444449575
Serial number 31222241
Was working fine for just over 1.5 years until I smelt burning plastic. Disconnected the "cooker flip switch" power supply in my home's...
Hi there.
I’m trying to put a new ceiling light in that’s from IKEA but it has a blue wire and a white wire. How do I know which is live and which is neutral please?
Also can I check that I am going to do this correctly. The current ceiling rose has like maybe 6 wires all connected to a black...
Working on an electrical drawing and wondering if I can split a single 12/3 wire (blue&red together) into three 12/2 wires (2 blue & 1 red separated) using pigtails at an outlet so that the wires can travel in three separate directions as in fig 1? The wires attach in pigtails as represented in...
Hi, I recently purchased this light fixture and am confused as to which wire goes where. There seem to be 3 "white wires," plus a green wire that's wrapped around one of them. Can someone help guide me? Thanks!!!
Newbie here with a fear of fire and other DIY mahem.
OK--so I have this heating element for my ski boot bag (essential equipment in Switzerland) and it has two plugs--one for the car and the other for 240V household use.
As I was stumbling into the elevator at 5AM on my way to the slopes I...
I have an outlet outdoor, supported straight up by a galvanized pipe. It has only black and white wires, no ground. The galvanized pipe is extremely rusted and breaks exposing wires inside the pipe !!! On top of that, it has no electricity either.
Please note my home is ~40 yrs old.
I tracked it...
Hi, I have taken out an extractor fan from our bathroom to clean it out but didn't take note of the wiring and now I'm worried I'll wire it up wrong when I put it back. Can someone please advise me which wire goes where?!
The wires coming out of the wall are red, yellow and blue. The wires in...
I have romex 14/3 running in my shop on a 15 amp breaker. The back wall of my shop has outlets on the left and the right with the power feed in the center of the wall coming into a junction box. Can I use the black wire for the left side of the outlets and the red for the right side and both...
Hi :)
I'm looking to redo my kitchen early next year and am hoping to remove a defunct central heating timer from the wall and replaster. Once the timer is removed there will just be an exposed T+E from the wall which is disconnected (tied in a knot and buried in insulation) at the other end...
I need some help with a 240V baseboard heater problem...
I bought two smart thermostats for my home. I installed the first one and it powered on as soon as I flipped the breaker back on. Turned the breaker back off, and installed the second one. Flipped the breaker on and it worked too - yay...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.