hi all
Need some help here regarding cable tray installation on uneven suraface. This job was done a few weeks ago and need to wire a new supply for a sub main board. It's a new restaurant that is getting done. So need to supply power for kitchen appliances. My question is regarding cable tray install. Planning on bringing down cable tray vertically onto the wall fixed with unistruct brackets every 1.5m then have a manufactured swept 90 then coming along the wall about 100mm then have another manufactured swept 90 come up towards the distribution board. Now looking at the wall it is very uneven and you can get a side look at the cable tray. So my thinking as soon as I install the cable tray it will look good face on but as soon as you look at it from the side it will be all off line as the uneven wall surface. Does anyone have any ideas how to deal with u even wall surfaces or just don't manufactured bends on wall surfaces only when suspended? Any help will be much appreciated.
Kind regards
Need some help here regarding cable tray installation on uneven suraface. This job was done a few weeks ago and need to wire a new supply for a sub main board. It's a new restaurant that is getting done. So need to supply power for kitchen appliances. My question is regarding cable tray install. Planning on bringing down cable tray vertically onto the wall fixed with unistruct brackets every 1.5m then have a manufactured swept 90 then coming along the wall about 100mm then have another manufactured swept 90 come up towards the distribution board. Now looking at the wall it is very uneven and you can get a side look at the cable tray. So my thinking as soon as I install the cable tray it will look good face on but as soon as you look at it from the side it will be all off line as the uneven wall surface. Does anyone have any ideas how to deal with u even wall surfaces or just don't manufactured bends on wall surfaces only when suspended? Any help will be much appreciated.
Kind regards
