Fuse head blank help

[super]

Hi all thanks for taking the time to check in.

basically I'm trying to source the plastic studs you sometimes find on main fuse heads after a knockout is taken out for extra tails to a sub board then later when removed there's an exposed hole with access to the live terminal.ive looked everywhere an no one has any ideas.

thanks in advance for any help.

 

[markc123]

Good luck with that.

To my knowledge you'll be struggling for a long time to find anywhere that sells them.

A blind grommit (if it'll fit) ? About the best i can come up with.

 

[Andy78]

Try calling the DNO and relay the fact that their equipment has exposed live parts. Be firm and you should get somewhere.

 

[Knobhead]

The make will be on the service head, contact the manufacturer.

It begs the question, what are you doing?

 

[GLENNSPARK]

i`v seen a few heads where these plugs have gone ...
unsafe and i`v brought it to the attention of the person ordering the work as well.....
just to cover my arse...

 

[lamb]

Cut-out tee
Cut-Out Tees

 

[super]

Lamb you legend.

tony it's because I see exposed holes in heads and phase blocks from time to time and not happy to leave these exposed holes when people are routing around meter cupboards and storing stuff in fuseboard cupboards, makes me cringe at these ticking time bombs.

 

[HandySparks]

Cut-out tee
Cut-Out Tees

Seeing those, I wonder if an ordinary plastic golf tee would do the job. I've used a large plastic wall plug in the past when there's been nothing else suitable.