How are fuses installed in this isolator

[cprfenom]

Hi All,

Probably an obvious and stupid question, but how do the HRC BS88 Fuses get mounted in this Isolator

 

[westward10]

The fuse carrier is missing, it cradles into the two brackets either side of the unit without it you are stuck.

 

[snowhead]

What I do, and presumably others do, if you don't want it energised is to remove the carrier and hide it somewhere locally.
You'd need to find out who removed it and why.

 

[David Prosser]

Shouldn't the person who is going to issue the P.T.W. know of it's whereabouts.

 

[cprfenom]

That isolator was made redundant due to a new cabinet being installed in the extension of a new school. As it's still wired up with a busbar chamber we were looking to use it to supply another building. I will see what I can dig up.

 

[snowhead]

That isolator was made redundant due to a new cabinet being installed in the extension of a new school. As it's still wired up with a busbar chamber we were looking to use it to supply another building. I will see what I can dig up.

Maybe 2 + 2 = an answer.

 

[BruvDunk]

The Permit as mentioned above normally has a DOI listing all isolation points and information on who did the work etc etc...

So if a Permit was required to remove and carry out the work it will probably require the same to re-energize or modify, you need to contact the Safety Controller (Permit Issuer)..