M
MarkieSparkie
Just noticed that the model EICR in the OSG contains at least one mistake ... Nominal Frequency filled in as 150Hz ... I sense an IET corregendum on the way.
Discuss Model EICR in OSG contains mistake(s) in the Australia area at ElectriciansForums.net
Share this page
- Reaction score
- 4
Makes me feel better about ticking the wrong box on many occasions over the years.
Inspector makes you feel like you have just sent a photo to gary glitter when he clocks it.
Inspector makes you feel like you have just sent a photo to gary glitter when he clocks it.
OP
Octopus
May be its a deliberate mistake to see how many people spot it. I can see another version being published - more money to sepnd
OP
MarkieSparkie
There is also another anomaly, Observation 6 states "No additional protection to low voltage circuits in bathroom, C3" I think no 30mA RCD or alternatively no supplementary bonding in a 701 special location warrants a C2.
Last edited by a moderator:
OP
SirKit Breaker
There will be lots of them. The proof reader will have been on the beer. You will find that they will disappear as and when new print runs are done.
OP
Deleted member 26818
No can't agree with that.
A C2 indicates the installation is unsatisfactory, yet technically we could still be wiring installations to the 16th, if the design pre-dates the introduction of the 17th.
As such I could finish an installation today, and tommorow it would fail.
OP
Deleted member 26818
The cut off point was that all installations had to be designed to the 17th from the 1st of July 2008.
Just the same as installations designed from the 1st of January 2012, have to be to the ammendment.
Just the same as installations designed from the 1st of January 2012, have to be to the ammendment.
- Reaction score
- 285
Thats the one!
OP
oldtimer
On page 172 records the protection device as BS 3871 (me thinks this is the old Wylex push button MCBs) so that takes a bit o finding you cannot say they dont keep you on your toes ie why make it simple when they can complicate it
Reply to Model EICR in OSG contains mistake(s) in the Australia area at ElectriciansForums.net
Share this page
Similar Threads
Hi all.
I only just noticed this, even after issuing many EICRs and EICs over the last couple of months, but in the Model Forms for Certification...
Morning all
So the site I'm based at recently had some work done (think partitioners). This package of work included electrical. This was...
Hi,
I've got both a solar pv and an ashp system.
The solar system also has 2 batteries and it's configured to fill the batteries first and then...
Hello all, I've just been perusing the AM2/E/S threads on here. Thought you might like a bit of a review.
If, like I did, you find yourself...
Am I on the right lines, I ask?
I've just recently moved into this house which is nicely equipped with a large 15 circuit CU unit with a split...
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.