Posting a message to the forum will remove the above advertisement
  1. angel While you're here, would you mind checking out our Electrician's Insurance section to see if we could save you a few quid? - Specifically our Van Insurance Deals and Public Liability Insurance Deals. Thanks for supporting the forum! angel

Discuss Questions in power engineering interview in the Electrical Wiring, Theories and Regulations area at

Thread Status:
Not open for further replies.
Please make sure you checkout our forum sponsors, many do discounts for members and, they keep the forum free to use.
  1. Jason82

    Jason82 New EF Member

    I would like to seek advice from experienced guys because I have interview test for my power engineering as below. Thank you.

    a) For 600A switchboard, what type of device setting need to do? Can I say that I need to do setting for direct acting for MCCB since more than 100A and earth fault relay setting?Any other else?
    b) How to calculate the earth fault setting since some use ELR and EFR with the setting range only 0.03A to 5A for the switchboard below 700A?
    c) What is the sequence for electrical testing need to do for the bungalow when electrical installation completed before supply is turn on? Can I say need the test below:
    earth electrode test
    Continuity test
    Ring final circuit test
    Insulation test

    d) How we apply the value of earth fault loop impedance value and earth electrode resistance value?
Similar Threads - Questions power engineering Forum Date
Newbie to the forum, couple of questions New Member Introductions Feb 21, 2018
Two basic switch/indicator questions... Electrical Forum Feb 14, 2018
Thread Status:
Not open for further replies.

Share This Page

Electricians Directory Post a Domestic Job Post a Commercial Job