SWA size. 6mm ok or 10mm needed?

[Peter Hahn]

Lots of heat lamps and extraction equipment by the sounds of it

Lol probably. But not sure. Customer request.

 

[buzzlightyear]

Idealy 2core SWA as only one phase needed. IS 6mm

only one single phase. or sub mains .

 

[Peter Hahn]

Hum ...... then shouldn't you know this? and unless you are a member of a CPS its still an issue..

Well done that is the topic

 

[Peter Hahn]

Quite a worrying response here. OCPD for the garage supply is the house CU main switch ?

As you are a new member could you state what qualification and experience you have, or pop it on your profile and set your profile to be able to be viewed publicly. This will help us help you best.

No it is not.

 

[DPG]

No it is not.

What OCPD will be feeding the SWA?

 

[Peter Hahn]

What OCPD will be feeding the SWA?

Thinki

correct that for him

Another helpful "guru" borned with knowlege lol bad day at work? Build your ego somewhere else gangster. Anyway thank you for your helpful and kind response. Good luck.

 

[DPG]

You'll get used to Buzz, don't worry

 

[Andy78]

Peter, a lot of questions have been asked of you about the design of this job. Have a read back through and come back with some info and we should be better equipped to help.

 

[Octopus]

This thread is best left alone ... the op is either a smart rss , a wind up merchant or a complete diy new bee

 

[Peter Hahn]

What OCPD will be feeding the SWA?

Well q

This thread is best left alone ... the op is either a smart rss , a wind up merchant or a complete diy new bee

As i said good luck to u guru.

 

[Leesparkykent]

Thread closed....going around in circles. @Peter Hahn feel free to start another thread but try and actually answer some of the questions and you might get more helpful replies. There’s no need to drag the thread down even further by name calling. If you have a problem with a post then report it and appropriate action/moderation will be taken if deemed necessary. Thanks Lee