Garage supply and changeover switch

[currie123]

Hi, wondering if some more experienced can advise on the following set up to supply a garage and for a small generator which will be used to supply a house during power cuts.

I have ran a 4mm 3core swa from non rcd protected side of consumers unit and protected by 20a mcb, route is underfloor and overhead on catenary wire, This terminates in garage at a small rcd protected c unit for a couple of sockets and a light.

At the same time I have pulled in a 2.5mm 3 core swa which will run from a 13a fused outlet in garage back to a changeover switch in the house, a small generator is planned to power the house in times of power cuts, so my 2.5 swa terminates to load side of fused outlet and feed side Is a flex which runs to the 16a 230v socket on generator.

Earthing is tn-c-s and I have used this as the earth for garage.

Thanks

 

[i=p/u]

but need tt for generator ??

 

[currie123]

Is this a must? Reason I ask is that I thought that the house and garage will still be earthed when changeover switch is switched to generator anyway

 

[i=p/u]

But what's protecting your13A spur

 

[currie123]

Way I thought of it was that as the generator is the supply in times of power cut then the fuse in the generator protects the flex to the 13a fused outlet and then the 13a fuse in the fused outlet protects the 2.5swa back to the changeover switch, from there all circuits are protected by their own fuses as normal and are earthed from suppliers earth which is connected to the neutral at the supply in the house end

 

[Knobhead]

The generator requires an earth rod, you can not use the DNO earthing arrangement.

The change over switch must have a centre off position and also it must break the DNO supply. There’s been too many fried jointers and linemen!

View attachment 14595
This is for a larger set up but it gives the general idea.

 

[currie123]

Okay thanks for clearing that up as I wasn't sure

 

[yellowvanman]

The generator requires an earth rod, you can not use the DNO earthing arrangement.

The change over switch must have a centre off position and also it must break the DNO supply.

I recently bought and installed a COS which didn't have an 'off' poistion.

 

[Knobhead]

Just to add a bit more confusion, you must also supply a neutral/earth link at the generator.

Back feeds in to the grid have been responsible for several deaths.

 

[Knobhead]

I recently bought and installed a COS which didn't have an 'off' poistion.

Naughty boy, look in the regs under generator / stand by.