Just popped round to a neighbours house, they have several of these in the kitchen that have failed
https://www.cef.co.uk/catalogue/products/4655073-10w-all-in-one-led-fire-rated-downlight
can anyone suggest a direct replacement 6000k Daylight downlighter, preferably one that has the same plug...
I'm not too sure which LED driver I can use to replace the one in the picture.
It states max 21V, does this mean any thing less than that is ok? It also says DC 24V though, which has confused me.
Would it be a constant current LED driver seeing as though thus one implies the voltage is...
Hi all.
I just wanted to see if anyone has had issues with Fans on the same lighting Cct as LED strip lights. I have a job where the fan mech on the
the next switch down on the same light Cct turns a LED strip on and off when running through the Fan speeds. Its not a switched active and the...
Hi, I have replaced some under cabinet kitchen tube lamps with LED ones. I followed the same layout and just replaced the lights. Each light (4 in total) is wired to its own fuse box and operated by the kitchen light switch on the wall. As well as each light being connected to a fuse box...
Is there an obvious reason why I can't just fit a plug onto my LED soffit downlights, fitted with a 5amp fuse and plug it into a socket rather than install a 5amp fsu? I'm fine with the plug being permanently plugged in as the socket gets no use anyhow. TIA
Hi, hopefully this is a quick one, in my new house I inherited a bathroom mirror with 4 small bulbs in it. This is hard wired to the main lightswitch.
When I first turned it on with new LED Bulbs I found that they were flickering. I took the mirror off the wall to see how they were wired. It...
Hello gents
I'm just after some clarification, I have a kitchen light fitting that uses a 2D 28W compact fluoresent lamp that I'd like to convert to a LED 2D lamp that I've bought because I thought it would work with the existing control gear.
I realise now that I have a magnetic rather...
Hi Everyone
I need a little advice please. I have bought a Coast Outdoor Led Bulkhead & PIR which states on the instructions that it can be fitted vertically and horizontally. It was fitted by the electrician horizontally, but unfortunately it appears that the PIR is looking directly down...
In the bathroom we have a panel above the wash basin with 3 x 12v Halogen downlighters powered through a single transformer.
I am looking to replace the halogens with LED equivalents with a 12v LED driver.
I have removed the bezel and there is a very thin black plastic ring but I can see no...
Hi
Simple question I think - is there a specific cable requirement for connecting up 240v 6w LED downlights in a daisy chain extending the current lighting circuit? Probably going to have 6-12 lights running off 1 switch. Aware needs to be 3 core with earth to all lights - more the rating of...
Hello everyone,
I recently changed a 3-way normal switch to a smart one (Kasa HS210). Both are not dimmable. The LED light started flickering after that. The problem remained even after I replaced the old switch back. I have tried tightening all the connections and wire nuts.
These are the...
Hi everyone
I am going to install LED lightstrips in the garden which would be on the SELV and obviously it needs to be installed using stepping down transformer however the lights needs to be on wireless switch technology which would require another transformer to feed the stepdown...
Hi all , hopefully somebody on here can help me out, I recently went to change a led unit in a workshop , cut power ,changed led unit , then when I switch power back on it didn't work and also took the bank of 5 lights down with it , disconnected it and the bank still doesn't work, checked...
I drunkenly bought a 4ft LED light bar on ebay. It supposedly lights up in different colours.
Now that it has arrived, I have no idea how I am supposed to connect it - and I suspect it may be intended for commercial use.
I don't really know what I ultimately intend to do with it - but now that...
Hi folks,
I just have a few quick wiring questions I could do with some help with please.
I'm in the UK.
Following advice on here and other places
I'm changing a couple of rooms from 12v halogen gu5.3 to 230v LED light fittings.
There currently is this round connector linked to the live &...
I have an electrical problem. I've a two gang switch and have just replaced some old 70s lights. I've matched the wiring but has an issue. Switch two works and switches light two on and off. Switch one however only dimly lights the first light. I've no idea why.
I've not touched the switch in...
There was a discussion some time back that wound its way to the subject of LED filament lamps - specifically those with fairly high output - but I can't seem to find it now.
I'm trying to find B22 GLS lamps producing around 1000+ lumens, but it's proving difficult without paying considerable...
Hi guys - I need to replace an LED driver for one of my downlights.
I know how to make sure the bulb is compatible with the driver, but as I can’t find the exact same driver as those which connect to the other bulbs, I’m worried that it might perform differently to the others.
My question...
I have 9 led strips fitted to a bookcase which is operated by an LED dimmer switch. The lights all turn on, off and dim, but after they have been on a few minutes 3 of the lights begin flickering constantly.
Is this an issue with the lights or the dimmer switch?
Thanks
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.