Ryefield Spares

[bigd]

Does anyone know where I can get the missing plain top cover plate for a 24 way Ryefield Board? (see photo)

Other than contacting Ryefield Engineering direct I've run out of ideas.

EDF has complained that it is unsafe and asked that the missing plate be re-instated. According to the Building Manager its been like that for years,but EDF are insisting. Bless

 

[telectrix]

make one. or get a local fabrication shop to.

 

[Leesparkykent]

As above make one.

 

[LankyWill]

just get some 4mm plate steel and get your angle grinder out. get some galv hinges and your laughing. Other than that you could pay ryefield £*** for a metal door.

 

[davesparks]

Just get one from ryefield, your not paying the bill personally are you?

In the modern world of legislation and liability, if you manufacture a part to fit a DB you have to accept the liability should any problem occur down the line. Fit a manufacturers part and it's their problem

 

[Bobster]

Is this the door you're referring to or the neutral cover plate?

 

[DPG]

Must be the neutral cover bar - you can see the door in the picture. Daz

 

[telectrix]

just get some 4mm plate steel and get your angle grinder out. get some galv hinges and your laughing. Other than that you could pay ryefield £*** for a metal door.

4mm??????? what is it, a bank vault? 1mm is plenty.