Recent content by wunatey

  1. W

    Using a consumer unit after removing total control meter

    Thanks for the reply, the sockets are already covered with RCDs and their is already space to connect the mains supply. Thanks again wunatey
  2. W

    Using a consumer unit after removing total control meter

    I have 2 consumer units, one normal and one for t control, I no longer have storage heaters so want to get the meter removed, can I then use the consumer unit to supply the sockets that were originaly used for storage heating, my immersion heater is also connected to this consumer unit so that...
    • wunatey
    • Thread
    • after consumer consumer unit control meter removing total unit using
    • Replies: 2
    • Forum: UK Electrical Forum
  3. W

    UK Immersion heater timer

    Once again thanks for your time,I think I will go with getting an electrician to change it over ,I will let you know how I get on,as it is not urgent, I will leave it until this covit is cleared up. All the best and stay safe.
  4. W

    UK Immersion heater timer

    Immersion Heater Thanks again for taking the time to reply,the only reason I am changing the switch is that, I only need the hot water from the immersion in the morning,it only takes about an hour to heat the water and I do not want to have the immersion on the whole night just to get hot...
  5. W

    UK Immersion heater timer

    Thanks for taking the time to reply,on the consumer unit their are 3 supplies,1 for storage heating,1 for convectors and 1 for the immersion,so I take it that the cheap rate would apply to the storage heating and the immersion,from that I can take it that if I want a permanent supply for the...
  6. W

    UK Immersion heater timer

    Hi I have a Horstmann e7bx water heater boost controller for my immersion heater which I want to replace with a timeguard trtd7n timer which is suitable for dual element ,the only problem is that the new timer has only got 5 connections and old one has 10,is this possible or do I have to get...
  7. W

    Kende Switch

    I have a Powercraft 25-130 welder the selector switch was stuck, it is a 6 position 0-6 Kende Switch with 4 banks,I took it separate and put it back together but what I need to know now is,when the switch is on position 1 what continuity readings should I get between the the different points on...
  8. DSCF9310.jpg

    DSCF9310.jpg

    • wunatey
    • Media item
    • Comments: 0
    • Category: Electrical Videos
  9. DSCF9309.jpg

    DSCF9309.jpg

    • wunatey
    • Media item
    • Comments: 0
    • Category: Electrical Videos

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock