Morning All!
Looking for some one to sense check a wiring diagram I have made for a switch panel in my car.
Ok so helpful information -
All switches are 3 pin LED toggle switches. I would like them to light up when activated.
The LEDs Circuit is currently in the car wired like they are in this and working.
Fan - The green cable is the existing wiring loom. I will be cutting the button off the end and re wiring it to the relay - Therefore just completing the circuit>
Map Switch - this needs to ground a pin on the ecu. On my diagram the ground from 30 and 87 look to join together, they wont be, it'll be two seperate cables.
Show Mode - Much like the Fan one. At present there is a button where the Blue wires connect. So would be just completing that particular circuit again.
Pink wires is the Accessory pin on the switches.
Does all this look correct?
Looking for some one to sense check a wiring diagram I have made for a switch panel in my car.
Ok so helpful information -
All switches are 3 pin LED toggle switches. I would like them to light up when activated.
The LEDs Circuit is currently in the car wired like they are in this and working.
Fan - The green cable is the existing wiring loom. I will be cutting the button off the end and re wiring it to the relay - Therefore just completing the circuit>
Map Switch - this needs to ground a pin on the ecu. On my diagram the ground from 30 and 87 look to join together, they wont be, it'll be two seperate cables.
Show Mode - Much like the Fan one. At present there is a button where the Blue wires connect. So would be just completing that particular circuit again.
Pink wires is the Accessory pin on the switches.
Does all this look correct?
