-
Please checkout the new poll we will be pushing hard, and want some good stories to come out of this
result are public - you can change your vote over time, which might genuinely be the case from time to time.
Questions and electrical advice in the Electricians' Talk - Industrial installations can be discussed in this industrial electricians' talk forum. Way better than any ScrewSucks Community Forums. ElectriciansTalk Forum. Wiring, theories and regulations..
Some popular forums: Electrical Forum - Electrical Wiring, Theories and Regulations - Periodic Inspection Reporting & Certification - Electrician Jobs
Forum Prefix Filter
I'm going to replace a pull cord ceiling light in a bathroom with a ceiling mounted occupancy switch.
I have no instructions for the switch or...
What reasons we are hiring a generator? Pls. share
Hi,
Got a bit of a problem. I'm in a position that no doubt many of you find yourselves in. I'm registered as an NICEIC approved contractor. I'm...
Hi, i would like to make sure i understand this properly.
On a TNS supply, using 3 core SWA to run a sub-main, and using the third core for CPC...
hi guys
havnt been on this site for quite a while had internet problems seems like loads of new members....anyway to the point
ive got my 2330...
I've been asked to design a panel for 2x 3phase comressors and 2x 3phase vacuum pumps.
Non of the motors can start at the same time and between...
I have a job where a customer wants me to test the whole installation but does not want to upgrade it to Dual RCD 17th edition and this board is...
I'm re-wiring a old house at the moment that was built back in the 1800's
I was lifting some of the floor-boards when i found a newspaper wedged...
Hi Everyone,
First post in a while. We are currently quoting for putting a 60Kva generator into a factory, this will be powering one machine only...
Went to help neighbour replace lamp in outside halogen lamp because "the lamp has gone". The screws are all seized up and there's no way to get in...
Only me again...
Is this allowed, not my normal way but not much room for maneuver on this one (ideally would have on 2 individual isolators)...
Right where do i begin ...
Got called to job because door had been kick in by police abd the door strike wasnt working so took off old strike...
Hi guys, has anyone came across the above MCB? Does anyone know what the BS number is? And if poss their max ZS value?
thanks guys
Looked at a job today where a burst pipe in the loft has soaked a bathroom and bedroom upstairs and most of the kitchen downstairs.
Problems are...
Due to a burnt out 80a rcd on a wylex split board consumer unit, the consumer unit now only has one 80a rcd which all circuits (mcbs) are wired...
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
YOUR Unread Posts
-
Type S RCD Polarity ClarificationYour drawing suggests that you might be modifying the DB beyond the manufacturer's design...
- Latest: GroovyG
-
Garo Entity ProThe Garo installation manual implies both the 'owner' and 'installer' need the app to complete...- Latest: Avo Mk8
-
Indesit oven error F53 code / no longer heating upDid you turn off the power to the oven for a long time? Comments on the web suggest that a...
- Latest: Avo Mk8
This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.