equipotential

  1. C

    Main equipotential bonding . . .

    A simple, yet interesting question. We are advised that when bonding services such as the water incomer, then the bonding conductor should be unbroken between the MET and the connection to the service. However, I have seen that it is possible to use the structural steel of a building to...
  2. tigerpaul

    equipotential bonding

    Just done a periodic, and found the water main bonding is daisy-chained off of the gas main bond. I seem to remember thats okay as long as the cable is unbroken at the first point of call. ( g/y sleeving stripped back at the earth clamp ) However the cable IS cut and then both ends are...
  3. D

    Are equipotential bonds needed for new circuit installed?

    Do the gas and water need to be bonded when you installl a new circuit? An example is a customer asked me to install a new rcd unit for a shower, do the bonds have to be installed to certify correctly?
  4. E

    Equipotential bonding

    Guys I'm about to change a Cu and the bonding cables are 6mm, I know they need to be 10mm but the unit is under the stairs in the centre of the house, the floor above is laminated, in other words I have no way of getting the bonding cables re-sized without destroying half the floor upstairs,Can...
  5. S

    PME systems and sub mains?

    Was working on an installation a few weeks ago (PME domestic) which had a sub to a garage which in turn had another sub which supplied a c/u in a shed about 20 meters down the garden. Got talking to mate of mine on Saturday who said that both the subs should be protected by an an individual...
  6. J

    Continuity (Main Equipotential Bonding)

    My practical for Inspection & Testing is coming up towards the end of the month and im a little unsure about how to test the main equipotential bonding for continuity. My tutor told me that one end of the Main Bonding conductor has to be removed from the MET in order to remove any parallel...
  7. S

    Crimping Main Equipotential Bonding?

    Hello, New to this forum and i've had a good look round to see if this question has been asked previously - apologies if it has, as i've been unable to locate! :) My question is - can main equipotential bonding consist of 2 pieces of wire crimped together? I'm aware that if 2 services are...
  8. M

    Gas safety equipotential bond

    Hi chaps my first post so please bear with me. I am just undertaking a periodic on a flat which is over the top of its integral garage in a block of three. It has a concrete floor and the gas meter is on outside wall of garage below. I was checking the main safety bonds and could not find the...
  9. M

    Main equipotential bonding conductors

    If I were to upgrade.....is this work notifyable:confused:
  10. K

    Size of equipotential bonding????????

    If you do a board change and the installation only has 6mm2 earth cable to its gas and water is it a requirement of the regulations that you change it for 10mm2? Or can you recommend its upgrade but if its declined just leave it? Help appreciated;)

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock