consumer boards (2)

[MARTY16B]

hi im currently pricing a job to change a consumer board/s, the question I have is there is a second e7 board, which is no longer in use, but somebody at some point has changed the fused spurs to single sockets. the main concern is ive read before about other sparks putting it all to one board , instead of two(is this ok ??) and they have then had problems with the e7 side tripping out regular , poss because there still using e7 heater's. in my case there arnt any heaters left so is it ok to combine the two boards into one??? any help would be greatfully received asap as im due to change these next week.....:tounge_smile: lso could I change the e7 to be on all the time as they have single sockets instead of fused spurs......thanks fellow sparks hope to hear from you all soooon

 

[londonlec]

Can you get the supplier to remove the E7 meter (if its not being used), then put all the radial circuits into a larger main CU.

 

[Octopus]

Not enough facts to give an informed answer.

 

[Deleted member 9648]

Just disconnect the E7 radials and feed them off your new CU. If that creates too many circuits it would be acceptable to double up the radials 2 to a circuit.