How to wire a danfoss rx1 stat to an ideal logic combi

[ryan510]

Hi

I recently fitted an ideal logic combi and now the customer would like a room stat fitted. I bought a danfoss rx1 but cannot seem to get it to work. Ive taken the link out of the boiler and wired those terminals to n and l in the receiver but it didnt work? Any help would be much appreciated.

 

[jaypp]

have a look at p27/28 of this re neutral. also, check the stat is compatible. others on here far more knowledgable but hope it helps

http://idealboilers.com/installer/w...2/2014/01/Logic-Combi-Installation-Manual.pdf

 

[paul_h]

Is it the wireless stat version?

If so take a live/neutral to the receiver (either from load side of the switched spur or from the boiler mains connections) , and from terminals 2 & 3 take a two core flex to the connections in the boiler where the link was.

Or use 4/5 core flex instead of 2 x 2 cores.

 

[Geordie Spark]

Is it the wireless stat version?

If so take a live/neutral to the receiver (either from load side of the switched spur or from the boiler mains connections) , and from terminals 2 & 3 take a two core flex to the connections in the boiler where the link was.

Or use 4/5 core flex instead of 2 x 2 cores.

YES!! .... a much more elegant solution!

Nowt worse than seeing two bits of 3 core sticky taped together and flapping in the breeze.

 

[shanky887614]

YES!! .... a much more elegant solution!

Nowt worse than seeing two bits of 3 core sticky taped together and flapping in the breeze.

Tape?

Use small tywraps its much neater

 

[jaypp]

deleted my post

 

[Geordie Spark]

Tape?

Use small tywraps its much neater

Aye ... but one run of five core is MUCH neater!!

A Twin patress box (NOT a Double) to fit both the fcu and thermostat receiver on side-by-side makes the job neater still.