Insulation Resistance Test??

[Kev2632]

Did you disconnect the RFC conductors at the CU & check ?

nope, dont normal have too, but can anybody answer this one" if you are testing at the Consumer on the 1 side of the RCD, and everything is isolated are you are doing L-N on the ringmain, will other circuits on that RCD affect the result of the circuit being tested????

 

[Specialist]

nope, dont normal have too, but can anybody answer this one" if you are testing at the Consumer on the 1 side of the RCD, and everything is isolated are you are doing L-N on the ringmain, will other circuits on that RCD affect the result of the circuit being tested????[/

If you find what you think is a fault on an insulation test of any circuit then the first thing to do is completely isolate it from the board & test again.

 

[Kev2632]

nope, dont normal have too, but can anybody answer this one" if you are testing at the Consumer on the 1 side of the RCD, and everything is isolated are you are doing L-N on the ringmain, will other circuits on that RCD affect the result of the circuit being tested????[/

If you find what you think is a fault on an insulation test of any circuit then the first thing to do is completely isolate it from the board & test again.

Thanks for that, but if you are testing at the Consumer on the 1 side of the RCD, and everything is isolated are you are doing L-N on the ringmain, will other circuits on that RCD affect the result of the circuit being tested???

 

[Flying Ninja]

As posted before, Remove all cables from CU if you are getting these sort of readings and re test. Other circuits may have an effect as the neutral and earth will be linked as you are only isolating the line between circuits.

 

[Mark_Burgess]

Thanks for that, but if you are testing at the Consumer on the 1 side of the RCD, and everything is isolated are you are doing L-N on the ringmain, will other circuits on that RCD affect the result of the circuit being tested???

I see what you are saying, and as long as all other MCB's, RCD's and the isolator switch are open.

However, is there only the one ring circuit?
I think you have to disconnect and confirm continuity as someone may have done a mix up of cables in the consumer unit.

 

[Kev2632]

As posted before, Remove all cables from CU if you are getting these sort of readings and re test. Other circuits may have an effect as the neutral and earth will be linked as you are only isolating the line between circuits.

Yea thats very true, doesnt some switches like 13amp switches fused, cooker switches, shower switches always isolate the neutral as well?

 

[Kev2632]

I see what you are saying, and as long as all other MCB's, RCD's and the isolator switch are open.

However, is there only the one ring circuit?
I think you have to disconnect and confirm continuity as someone may have done a mix up of cables in the consumer unit.

Yea just 1 ringmain doing the whole house, but when you disconnect the circuit and checking for continuity are you meaning just Ring Continuity aye?

 

[Mark_Burgess]

Yes, to make sure that is the ring and not mixed with another ring or spur by some previous meddler.

 

[Kev2632]

Yes, to make sure that is the ring and not mixed with another ring or spur by some previous meddler.

Yea thats very true, it just had my head scratching today, because ive never really had such a low reading on L-N before, but it seems common

 

[Flying Ninja]

Yea thats very true, doesnt some switches like 13amp switches fused, cooker switches, shower switches always isolate the neutral as well?

Yes, They are double pole switches.