24v

Recent contents Top users
  1. I

    Fire Alarm Relays 24V

    Good evening! Don’t have a huge deal of experience with fire alarms but having to work on a conventional system at the minute with various signals and “shut offs” being activated by the on board relays. All relay outputs currently used up in the panel but need to setup another “shut off” for...
  2. M

    Armoured wire for 24V system

    Hi All, I hope you are doing ok. I have a question regarding the 24V system. I am going to build a pergola and I could install 4 panels on it. The inverter and batteries would be in a building that is about 3-4m away. What armoured wire should I put in the ground in advance to connect these 4...
  3. L

    24v Transformer specs

    I’m building a vacuum exposure unit…..and so I’m sourcing a 24v transformer to match load of 24v timer…….timer will control qty 10 x 18 watt fluorescent bulbs. ….Apart from the transformer being 24v do I need to pay attention to any other transformer detail…such as the amperage and wattage of...
  4. R

    Today's equivalent of the Bosch 24v SDS +

    So back in the early around year 2000, I was a data networks installer and had a Bosch 24v SDS drill, it was awesome, did pretty everything I could though at it, from using 25mm bits through 40cm of concrete wall etc being in my hand all day while putting up trunking etc, then adding the chuck...
  5. M

    24V dc lighting circuit

    I am having a flat roof constructed with solar panels over. As it is a cold, vented flat roof I will be having 175mm of Cellotex insulation immediately above the ceilings which I am reluctant to dig into to fit downlights (which I have never been the world's biggest fan of anyway). My thoughts...
  6. A

    12v or 24v for efficiency

    Hi, I understand some basics about wattage, volts and amps etc but I am trying to decide what would be the most efficient system Situation - 2 x 110 amp hour 12 volt batteries wired in parallel. Use these to heat approximately 8 liters of water through a DC water heating element. Which of...
  7. kaicornew

    I've got 24V computer fans, and I'm trying to figure a way it connect them to my computer

    I've got 24V computer fans, but the output for the fan power ports are 12V, and I'm trying to figure a way to it connect them to my computer. The other problem is that the fans only have two wires compared to the four-pin ports inside my computer, so is there also a way to convert them to the...
  8. P

    Anybody have experience installing ceiling speakers?

    Basically I've got a lithe audio ceiling speaker, problem is it comes with a 3 pin plug and some people say they've has theirs installed by having a socket inside the ceiling. I 'm pretty sure that's not Ideal, it needs 24V 2.5A but I can't just buy a transformer as it's got one of those round...
  9. D

    24v led strip light

    Hi i have a home bar set up there is a 24v AC transformer powering the led in the beer tap font it has unused outputs, im wondering could i use this for a led strip light for handyness? I cant find any AC led strips lights, would i be better off just get 12v ones and plug into a socket? Thanks
  10. G

    UK 24V LED Driver

  11. W

    Led tape lights: 24V vs 12V, triac vs magnetic?

    HI, My project involves installing under-cabinet lights. Wiring is there and waiting. Have any of you seen differences, gains, sacrifices by using 12v or 24v tape lights.... or Triac vs Magnetic dimmers? Have you had any difficulty with dimmer switches with either? (not looking for Zwave...
  12. HappyHippyDad

    Calculating volt drop on 24v, supplying LED lights.

    I'm getting a little confused about volt drop and 24v. I want to fit an LED strip light. 8m of lights 7w/m. It would be easier to have the 24v driver approx 10m from the beginning of the strip of the LED strip. I'm not sure where to start to know if this will work without any effect on the...
  13. GoBeau

    Why are the first 5-6 LED’s on my 24V LED Lighting Strips not lighting after a connector is added?

    I just installed some 24V LED Lighting Strips single colour in my kitchen and it seems at every point where I added a quick connector that connects a 2 wire conductors to the LED Strip that the first section of LED’s don’t light up (about 5-6 LED’s). The plastic connectors are the type where...
    • GoBeau
    • Thread
    • 24v added after connector first led lighting strips
    • Replies: 1
    • Forum: Lighting Forum
  14. D

    Will a 24V 16A relay work?

    I have an inverter powered by a car battery that I use when 220V power goes off (see block 1 below). I use a battery charger to charge up the battery before I can re-use it (see block 2 below). Id like to connect these devices so that the battery is charged when 220V power is available. (A...
  15. A

    24v supply in boat

    My dad is a fisherman and his boat has a 24v supply. Was wondering if anyone could help me with this. He has said that when he connects a 24v light to the live that comes into the light fitting and then puts the neutral to the engine bay off the boat that it's lighting up the bulb and it...
  16. D

    24v DC fuse

    Hello to everyone. In 24V circuits, sensor, plc etc. I want a fuse that blows in cases of short circuit and high current, (not glass fuse), do you have a suggestion of rail type, short circuit and current protected (24v) fuses that I can put in the panel? It is not a problem for me if the fuse...
  17. D

    Stepping down 24v to 5v (bell wire)?

    Long story short, thanks to the help of a few members in here I'm close to finishing a swap for my old alarm system to a new ring system. Wire previously used for the keypad has been identified and the alarm box stripped out. 2 questions: 1. Is it safe to terminate both the keypad bell wire...
  18. C

    Connecting a 24V supply to some crimped wires

    Hi All, This is probably a very straightforward question, but I'm a bit confused about what I actually need to do this. I have a device that came with a 12 pin connecting cable (unwired) that is used for data transfer and power. I can deal with the data cables, but the 3 wires for the power...
  19. K

    Can you charge a 24V battery with a 54.6V charger?

    Sorry guys for my ignorance !
  20. J

    Dimmer switches for 24v LED tape lights

    Hi All Am on a job tomorrow and while there customer wants me to investigate newly installed 24v LED tape lights that keep flashing on and off. These are on a wall mounted dimmer. If tape lights and transformers are both dimmable which apparently they are this suggests problem is with the...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock