domestic

  1. Mark42

    Three phases in single domestic kitchen grid box. OK or not?

    I'm fitting a small kitchen in my remote office/workshop with a limited, existing, supply (3 phase/20A MCB on a long 4 x 10mm SWA). I need to think carefully about diversity and load balancing. My proposed solution is to install individual final circuits for every appliance (Small hob, Small...
  2. Baddegg

    Scope for Stroma domestic installers....

    Popped up my corner shop this morning and the owner grabs me and says he’s been waiting to see me.....takes me out the back and asks can I change the consumer unit for him, straight forward enough job except the unit encompasses his flat above (domestic) and 2 rfc circuits in the shop below...
  3. D

    2399 Solar PV Course for Electricians for Domestic Installations

    What everybody’s thoughts on the 2399 solar pv course? Has anyone done the course? Is there a big market for self employees electricians going into installing solar panels in domestic premises?
  4. N

    Steel conduits acceptable for earthing in domestic property ?

    Evening Just been to quote for a consumer unit upgrade. Found that the board was from circa 1960 and wiring looked original also. No alterations have been made with exception of a few faceplates renewed in the kitchen. Red and black single cores going into an adaptable box at the back and...
  5. B

    Replacing switch on a domestic heater - DIY question

    Hi. I want to replace a faulty switch on a heater circuit but need some advice - photo of circuit attached. Heater has 2 simple on/off switches - one turns a 1Kw circuit of heaters on, the other a 1.5kw circuit of heaters on, both can be on separately or together to give a possible 3 levels of...
  6. N

    What are my options next just got niceic Domestic installer

    Hi all just got my niceic Domestic installer assessment passed what should I do next. Ive only got my 2365 level 2. Passed the 18th edition and building regs exam for part p been working for some one for 18 years how hard is it now to go alone
  7. B

    Clips melted in domestic 60’s 3 bed

    Evening all, found a strange one today, pulled a few ceilings down in a property and found that the clips had melted! Not just on one circuit, it’s on 2 Different lighting circuits, a radial and the gf ring! Going to do an ir tomorrow morning just ran out of time today. Any thoughts or seen it...
  8. D

    UK 3 Phase PME to domestic building?

    Good evening all.. I have recently installed a new 100amp 3 phase supply for a domestic premises with outhouses. The incoming 100 amp supply is PME and approx 30 metres from the main dwelling, a new metering cupboard was built for the new head and meter. I installed a small sub board and two...
  9. C

    Unsatisfactory Domestic EICR - Should I rewire or spot fix

    Hi All, I am about to buy a 1930s house for which I have got a Unsatisfactory rating for the Domestic EICR. I am now in a bit of fix in deciding whether I should go for a complete rewire or just fix the issues raised in the report. I am also planning a back extension in the next 6 months and...
  10. lmi-pa

    Am I legally allowed to change a light switch on domestic without Part P?

    My friend rents out a house to someone and the light switch needs replacing like for like. This is obviously a simple job but as it is rented would need to be officially done by someone qualified. I am an industrial electrician and have an NVQ level 3 in electrical maintenance and have been...
  11. Phil Thompson

    Domestic and Commercial

    Phil Thompson submitted a new resource: Domestic and Commercial - Let us light up your life!!! Read more about this resource...
  12. B

    Domestic electric fires

    I recently purchased a Dimplex Yeo 20 electric fire, and I'm trying to find out what type of original bars are fitted. Dimpex went site is very poor so no luck there likewise with Amazon questions when raised after purchase from them. My question is are the Infra-red silicon elements advertised...
  13. Pete999

    Fusing SPDs in a Domestic Insrallation

    Question Can anyone, direct me to the correct sizing and fusing of SPDs used on a Domestic installation? I asked the question at ELEX earlier today, but all I got was nonsensical techno babble from the Chap on the stand, to be honest I don't really think he knew what I was on about. I ask...
  14. A

    UK Domestic electrical

    Hi everyone I don’t really post things on here but here goes I’m a qualified spark and have recently passed my testing course I currently work for a company doing commercial and industrial but wouldn’t mind going into domestic but mainly new builds spoke to a few sparks and they all say it’s...
  15. RutlandFox

    Professional Domestic, Commercial, Industrial Electricians Staffordshire - Fox and Fox Electrics

    RutlandFox submitted a new resource: Fox and Fox Electrics - Domestic industrial and commercial electricians. NAPIT registered. Read more about this resource...
  16. Dannyboybl00

    Pro Electrician West Sussex Qualified Electrician - Matrick Electrical Services Ltd

    West Sussex Electricians - Matrick Electricial Services Ltd I’m an East Grinstead based electrician and have lived in the area for over 30 years. I’ve been involved in the Construction Industry for 20 years and have Project Managed and Site Managed around the UK for almost 18 years. During this...
  17. M

    Only 2 brands for domestic type A rcd/rcbo + type 2 spd in board??

    Looking around I'm wondering if I'm going mad. Would have thought type 2 spd next to main switch and type A (not type AC) rcd/rcbos would be the standard everyone should be looking for now (even if it's just recommended and not strictly required in domestics). But only Wylex and Schneider seem...
  18. Dan

    Electrician in Berkshire | ABC Electricians Berkshire - Domestic Electrician Berkshire

    Dan submitted a new resource: Electrician in Berkshire | ABC Electricians Berkshire - Domestic Electrician Berkshire - Electrician in Berkshire | ABC Electricians Berkshire - Domestic Electrician Berkshire Read more about this resource... 1566967845 THIS IS A TEST LISTING. PLEASE DON'T CALL...
  19. W

    Codes domestic eicr best practice

    Hi just looking for any tips and knowledge. When carrying out a domestic eicr I’ve noticed a pattern such as often No metal board No rcd protection Not to ip 4x or 2 x I’m still picking up on things to put and don’t want to get into a habit of jut the same ones. Any other recommendations in...
  20. E

    Branching out to the domestic world

    Hi all, Just after a bit of advice... Time-served (Elec/Mech), 18th edition, 2392 Initial Verification, 12 years experience in industrial environment with experience in domestic work along the way. Looking at starting to build up a bit of a client-base/reputation in the domestic world with the...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock