flat roof

A flat roof is a roof which is almost level in contrast to the many types of sloped roofs. The slope of a roof is properly known as its pitch and flat roofs have up to approximately 10°. Flat roofs are an ancient form mostly used in arid climates and allow the roof space to be used as a living space or a living roof. Flat roofs, or "low-slope" roofs, are also commonly found on commercial buildings throughout the world. The National Roofing Contractors Association defines a low-slope roof as having a slope of 3 in 12 (1:4) or less.Flat roofs exist all over the world, and each area has its own tradition or preference for materials used. In warmer climates, where there is less rainfall and freezing is unlikely to occur, many flat roofs are simply built of masonry or concrete and this is good at keeping out the heat of the sun and cheap and easy to build where timber is not readily available. In areas where the roof could become saturated by rain and leak, or where water soaked into the brickwork could freeze to ice and thus lead to 'blowing' (breaking up of the mortar/brickwork/concrete by the expansion of ice as it forms) these roofs are not suitable. Flat roofs are characteristic of the Egyptian, Persian, and Arabian styles of architecture.Around the world, many modern commercial buildings have flat roofs. The roofs are usually clad with a deeper profile roof sheet (usually 40mm deep or greater). This gives the roof sheet very high water carrying capacity and allows the roof sheets to be more than 60 metres long in some cases. The pitch of this type of roof is usually between 1 and 3 degrees depending upon sheet length.

View More On Wikipedia.org
  1. patoune

    UK Flat roof electric velux > 'no contact' message on pad

    Hello, I've got an issue with my electric flat roof skylight velux: the pad reads 'no contact' with the flat roof velux. Please see attached picture. Have you come across this issue before? The plug is switched on. Thanks very much everyone!
  2. D

    Routing cable through flat roof

    Hi all, I'm just trying to route some cable accross a kitchen which has a flat roof. I've had a look at the ceiling void and could pass a cable over the top of all the joists / rafters (there's quite a good gap between the top of the joist and the insulation) but would that contravene the...
  3. G

    Drilling Flat Roof Joists

    Are we allowed to do this ? If yes is it the same hole size/distances as floor joists ? I normally use the safe zones, but this isn't possible as its like an all glass byfold door type extension. I'm thinking I can as surely floor joists have just as much weight on them, thought I'd see what...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock