So I'm starting out a new rig and I'm fresh out of college with my level 3 without any experience and I think that I need to still have the knowledge and the practice of terminating cables, stripping cables and having a good understanding of different circuits and how they work. I will also...
Hi all, looking for some advice with regards to extending cables for a consumer unit change. The old board is a mess inside with cables being cut short etc. What's your go to method for extending. When I've only had to extend a couple I've used the Ideal inline splice connectors, but this is...
Hi guys,
my brother is building a bar in his garden that is timber framed and wants some power to it.
The main board in the house has a pme earth and there a no spare ways in the board. From this board there is a 4mm t+e on a 32amp breaker off the rcd side supplying a board in a little out...
We are having our kitchen moved to a different part of the house. I have asked that the wiring for the new kitchen be using a new consumer board. The old kitchen will be changed into a bedroom. What changes need to happen to sockets and wiring of old kitchen. Also in the new room where...
Hi whats the situation on following!
went to wire a bathroom today in old terraced property all looked good new board (last 6 months) full niceic member! certificates not to hand YET! looked in loft to find V I R cables! works out from board new cables run 2 mtrs into joint boxes picking up old...
powervan
Thread
board
cables
connect
connected
customer
newnewboard
problem
just done a board change on a domestic property and i have got faults on 2 32 socket circuits nitemare is there any quick way other than obvious of starting from the first socket then all around the ring, can i measure the fault out with my megger please helppppppppppppppppppppppppppppppp
Hi Guy's, first post for me.
I have a client who has asked me to replace a rewireable fuse board for an 8 way split load board. No problem. Until I look into the existing board to find that the spark who fitted it took great pride in ensuring that the outgoing supplies were measured to the...
FAA Greenie
Thread
aus
board
circuits
existing
newnewboard
short
through
too
trunking
wiring
I have wired a 16mm to supply a new board for a extension I have been told I cant use a 30ma rcd to protect this cable due to discrimination with the rcds on the new board. I think I will have to chop the cable in to 50mm of the wall:eek:, would this be the only way to get around the problem.
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.