unused

  1. J

    Terminating unused blue wire at the thermostat

    Apologies if I'm posting in the wrong section! I hope to replace an old broken analog central heating thermostat with a digital one. Background: There are 4 wires coming into the box: yellow/green, blue, red and yellow. The yellow/green is tucked away, physically floating about. The other...
  2. S

    Napit unused forms - loads.

    *** OBVIOUSLY BEFORE I SELL THESE TO SOMONE, YOU'll NEED TO SHOW YOU ARE A MEMBER OF NAPIT! *** "NAPIT Periodic Report on an existing electrical installation" code NA/PIR/001 (V1) - runs from serial number 55657 to 55675 (19 sets left). Obviously not for use on a domestic but still useful to...
  3. J

    Unused radial circuit

    Hi there I want to install 2 triple 13 amp sockets on a radial circuit which was used for an immersion heater (now removed). The circuit terminates in a 16 amp RCD in a new CU. The wiring passed inspection for the immersion heater. Is it OK to reuse the circuit for this purpose and can I use a...
  4. sjhall

    kewtech 1710 voltage tester

    For sale , unused kewtech 1710 voltage tester. Unused with instructions http://isswww.co.uk/VoltageContinuity-Probes/Kewtech/Kewtech-Kew1710-Voltage-Tester/ £70 is the cheapest I can find it... Offers
  5. S

    Bits for Sale

    Seaward MFT with Cert of conformity - unused £250 50m Wander lead - unused £30 Super Rod Mega set - unused £50 The new Tech LC Veto Pro Pac unused - £90 Cheers
  6. Dan

    Clearing up unused accounts

    I'm clearing up unused accounts on most of the forums. So if people haven't confirmed their new account within 30 days, I'm assuming they're not going to and they'll be erased. If people haven't logged into the forum for 300 days, and have no posts under their account, I'm assuming they don't...
  7. M

    Do I really need to terminate this unused wiring?

    Hi all Some time ago, we removed a wall light in our lounge... Unsure of what to do with the remaining wire, I put the live and neutral into separate choc block segments, then taped them up separately. It has been left like that for some quite time. But we are now having a spurge to finish...
  8. S

    Consumer Unused Spare ways

    I am fitting a new dual CU that comes with 10MCBs. For those that are unused is it acceptable to just leave them installed but switched off and identified as unused. Or should they be removed and replaced with blanks?
  9. kingeri

    Unused core in T&E

    Quick question. I was adding a 2 way switch to a lighting circuit and discovered a T&E where only one wire was used. he second had just been cut off and not used. I always connect unused cores to the CPC and sleeve green/yellow. Is this common practice or just me?
  10. B

    MFT 1553 Megger.

    HI,new to this forum for one reason and that is to sell my unused megger,i received this as security payment for work i had done for a company who are unfortunately no longer trading.I have no idea of value and first reasonable offer will be accepted, Regards, John.
  11. the pict

    unused phase

    I want to run 4 showers from an unused phase in a hotel, these are already installed and in use but are supplied from another board that is maxed out as far as demand in concerned with the occasional tripping on assorted circuits, I have had the chaps from the DNO who say it is not a problem to...
  12. S

    DC 12V ~ UNUSED ELEC generated by Alternator OR Solar Panels: DISAPATATED OK?

    My point here is, surely if generated ELECTRIC (DC 12 Volts: Solar Power or Alternator) has no immediate STORAGE (Car/Leisure BATTERY), then surely this generated ELECTRIC is DISAPATATED to nothing, or some HEAT. Either: ~ The unused electrical charge passes as HEAT (That is the electrical...
  13. M

    Sanyo HIT-240HDE4 PV panel New unused still in the box.

    Hi, I am an MCS approved PV installer, I have one Sanyo HIT-240HDE4 PV panel New unused still in the box I have this one left over from a instal - it just would not fit on the roof space we had. Cost me £552 one month ago, will take an offer. Mob 07970035482 Alastair. Any questions please...
  14. Goody

    To remove or not to remove the unused MCB's

    I came across a CU with one RCD. Two ring circuits are on 32 Amp MCB each and 3 lighting circuits on 6 Amp MCB each; the other MCB’s are left on the CU serving no circuits. Should I remove them and put blanking plates (plastic) to cover the hole or leave them there with label “not in use” This...
  15. I

    For Sale Megger 1552 Multifunction Tester Unused

    All I've done since buying it new 12 months ago is put the batteries in, attach the strap and check it out. Original receipt provided for peace of mind so you get the remaining 2 year warranty - the original calibration has just lapsed. £450 delivered, £430 collected. Can send photos if...
  16. S

    unused fcu in kitchen

    Some advise would make my life alot easier and get my wife off my back. ok here goes I have an unused fcu in the kitchen but it is still live. I want to know if it would be safe to tape up any wires so i can replace the front cover with a blank so it (looks better. its my kitchen)...
  17. T

    Unused ways on schedule of test results

    When filling in the schedule of test results, for example on a consumer unit change, do you record any unused ways?? eg. 1 spare 2 spare rcd module 3 kitchen sockets 4 upstairs lighting 5 shower 6 spare rcd module 7 upstairs sockets 8 downstairs lights 9 spare
  18. M

    Items for sale inc unused Megger 1553

    Hi, I am selling these items as I trained as an electrician then decided not to persue it. Hitachi DH24 110v SDS drill, fully boxed and unused. It cost me about £120, looking for £60. Megger MFT1553 17th Edition tester, fully boxed, unused other than to test it. Is callibrated until 20th...
  19. O

    Concealing unused sockets

    This is my first post on the Forum and I have a question regarding concealing unused sockets. The house I am working in is having a new kichen installed. The existing kichen sockets are part of the single house ring (1978 4 bed detatched). Additional kichen appliances will be installed so I want...
  20. brucelee

    wiring external pir floods off unused immersion circuit

    hi everyone, just want to know if it ok to wire 3 pir floods off immersion ie 16a at ccu but fused down to 5a with sw/f/spur is it poss to wire two fused spurs then to two seperate switches two floods on 1x 2 g 2way from 1 sw/f/spur and one of the other is this ok as...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock