Dodgy trade pictures for your amusement! - 1 Million Views!

[pc1966]

Removing a room of downlight converters, not only did they convert the large ceiling holes, but also the connections ... by means of the MR16 lampholder!

Well it is creative, you could say that!

 

[pc1966]

Creative adaptation of a 13A plug:

 

[Avo Mk8]

Creative adaptation of a 13A plug:
View attachment 113818

Top notch job

 

[pirate]

There's never anything good to be found at the end of a length of orange flex

My neighbour's neck would be a good start...

 

[Greenarmy]

There's never anything good to be found at the end of a length of orange flex.

I have never realised before, but that is very true

 

[Darkwood]

Wow - this thread is still getting plenty content, at this rate it will be the first thread to hit 1million views soon.
Not bad for a Electrical trade forum I must say so myself

 

[Pete999]

I have never realised before, but that is very true

 

[LewisM]

Fans going to be fun to change

 

[brianmoooore]

Fans going to be fun to change


View attachment 113880

Not too bad, as long as you can release the two clamp bands holding the motor/fan assembly in place, and you are replacing with the same model.
Motor and fan just slides out, leaving the frame and pipes undisturbed.

 

[timhoward]

I turned up to change an outside light. This was the supply cable as I found it and the photograph to explain to customer why it needed to be a bigger job. Needless to say I took it out of service and ran a new cable.
When the place was rewired I think no one fancied tackling the slate roof to replace it.

Twin (without earth) and tinned copper conductors, so it's probably sat here in its buckle clips since the early 60's