Discuss Downlight holes too big. in the Electrical Tools and Products area at ElectriciansForums.net

Amp David

-
Mentor
Arms
Reaction score
904
Looked at a job which is to replace eyeball downlights in a bathroom to IP65 fixed downlights. However the holes for the existing lights is 95mm and can't seem to find any IP fittings that will cover the hole completly.

Is there anything that can be bought that fits to the fitting to cover the hole once the fitting is pushed into the ceiling?
 
you can get adaptor kits but not sure if they make IP65. alternative is to make patch discs for the old holes, secure with a bit of lath above and fill edges, and drill new holes to suit new fittings.
 
had this prob before.........................no solutions out their bud, u will have to reboard ceiling if they want spots in same place!.......................as previously posted, the conversions will be no good for bathrooms, i looked absolutely everywhere too, including calling manufacturers.
 
fiar play dazza........................where wer u about 5 months ago!!!!!!!!!......lol...................i looked absolutely everywhere too.......................apart from here!
 
Could actually use IP44 TBH, just inside zone 1 as the ceiling has at some point been lowered. Just alway fit IP65 in 99% of the jobs, but like IQ says, just erring on the side of caution i think.
 

Reply to Downlight holes too big. in the Electrical Tools and Products area at ElectriciansForums.net

Similar Threads

Hello folks, Just looking for a little guidance please. I am sure that this is something that many of you have come across before. I am...
Replies
7
Views
2K
I need your help please once again in tracing a fault. Am DIY but not clueless. Converting former kitchen into 2 rooms: bathroom and laundry. The...
Replies
24
Views
2K
I have been asked to look at this report as the customer has been given (in their words) 'A very high quote plus VAT'. It doesn't look well...
Replies
5
Views
651
I have an older Crouse Hinds board with a 200A service. Due to recent rehab on the house, I found I have the need to install a sub panel. I...
Replies
1
Views
1K
Hi all, Getting the utility room redone at this project house and the misses is absolutely adamant she wants downlights. Couple of reasons for...
Replies
26
Views
3K

Electricians Tools | Electrical Tools and Products

Thanks for visiting ElectriciansForums.net, we hope you find the Electricians Tools you're looking for. It's free to sign up to and post a question yourself to find a tool or tool supplier either local to you, or online. Our community of electricians and electrical engineers will do their best to find the best tool supplier for you.

We also have a Tiling Tools advice from the worlds largest Tiling community. And then the Plumbers Forums with Plumbers Tools Advice.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock