D
Davep01
Hi,
I went to go and look at a job replacing a consumer unit. It is a TT system, with an old Wylex board. It is protected by an old earth leakage device as described in the post I have attached. Would it be acceptable to leave this connected and then have a RCD protected board in series. It would just make things easier because I could use it as a point of isolation.
I only had a quick look at the job but I will be go back tomorrow to have a bore in depth look.
If if anyone has any advice it would be greatly appreciated.
Thanks,
Dave
I went to go and look at a job replacing a consumer unit. It is a TT system, with an old Wylex board. It is protected by an old earth leakage device as described in the post I have attached. Would it be acceptable to leave this connected and then have a RCD protected board in series. It would just make things easier because I could use it as a point of isolation.
I only had a quick look at the job but I will be go back tomorrow to have a bore in depth look.
If if anyone has any advice it would be greatly appreciated.
Thanks,
Dave