pendent problems BIG TIME

[Engineer54]

Snip some of the strands off lol

Some?? Don't you mean most?? 12mm of conductor going into a terminal on a pendant rose!! Something i'd like to see!! lol!!

 

[chrish_1977]

This post + mouth full of coffee = wet phone

 

[thomas-1981]

If you could upload a pic I would be happy to tell you, your a wind up merchant.

 

[thekernal]

very funny

 

[snowhead]

6mm,,,I think it's a wind up and he's really done it in 4mm.

 

[kingeri]

Aaargh not another wind up thread. Why do it. Nothing on telly?

 

[Rockstar94]

You should of wired it in bell wire, coiled it up a couple of times then not only do you have a great light source but a great room heater too!!

 

[TAZ]

It's 100w per point not 1000w

 

[Elmer BeFuddled]

It's 100w per point not 1000w

From Gremlins:

"Bright light! Bright light!"

Perhaps the 6mm is the overall dimension of the grey sleeve (measured badly!!)?

 

[TAZ]

Nice to know someone understands the meaning of diversity with out going over the top!!!

 

[shocking_eg]

with most cable calcs done to the book you would probably end up with 6mm for most lighting circuits !!!

 

[Des 56]

Everyone seems to be jumping the gun presuming the post is a wind up

Has it not ocured to the members that the noob may actually be a plumber

If that is the case.we should remember their stupidity knows no bounds

 

[richy3333]

It's not a wind up, he's future proofing the circuit

 

[telectrix]

can't this thread be future proofed, as in bloody closed?

 

[ezzzekiel]

3 pages so far,

personally i think best to err on side of caution and use 10mm then just junction it to flex for light.

 

[dan86]

zzzzzz

 

[Knobhead]

I’m sorry, it will take me a while to procrastinate upon a suitable obtuse and preciositly precise answer.

 

[telectrix]

and i bet the last word will be "off". :banghead:

 

[Kamikaze]

At least the earth loop impedance will be low as long as he’s wired it as a ring…pml

 

[monkee]

he is having a bad week boys may be he has gone VAT reg this week hence the rise in materials

who vets this stuff any way haha