Programming key switch on an accenta G4

[john sleaford]

Hi can anyone one run through how I program a zone as a keyswitch on the accenta G4 alarm it has the remote key pad. I've installed a Konnected wireless interface which has a relay for setting the alarm from a mobile but I can't find the instructions for setting the zone as a keyswitch in the manuals at all. Thanks.

 

[telectrix]

go into zone config. select zone number, then zone type is "5" for keyswitch.

 

[john sleaford]

I've only got the led key pad.

 

[john sleaford]

How do I get into zone config?

 

[john sleaford]

Hi can anyone help I still can't config the zone as it doesn't show how to do it with the led keypad?

 

[telectrix]

dunno how to do on LED, if in fact you can. might be an idea to buy a LCD pad.

 

[john sleaford]

Spoke to a technician at honeywell who said the g4 can't have its zones programmed as a keyswitch so I might be screwed. How though does a GSM dialer set and unset the g4? As I know you can buy them

 

[homeauto]

Spoke to a technician at honeywell who said the g4 can't have its zones programmed as a keyswitch so I might be screwed. How though does a GSM dialer set and unset the g4? As I know you can buy them

Hi John, I’m in the same situation, I have the Accenta G4 with LCD panels. I’ve ordered the Konnected board and now searching how it can be remotely armed/disarmed. I didn’t realise you couldn’t program a zone as an arm/disarm function, I also thought the dialler may be a way around it. Let me know how you get on I will also do a little digging.

 

[john sleaford]

Thanks for getting in touch, I'm sure there must be a way, I was thinking of finding out how the set/unset input comes from the keypad and seeing if the konnected relay/momentary switch could make that signal thus setting the alarm but I'm unsure how to check this.