Programming key switch on an accenta G4

[Thesploog]

John

If you haven’t resolved your problem would you be willing to part company with your interface board. It sounds as though you actually need the new Konnected Alarm Panel board linked to the new interface add-on for what you are trying to achieve.

Jon

@Jon Mac and @ John Sleaford I have the same conundrundrum with the G4. I also want to use the Konnected interface. I don't want to remove my alarm panel completely because I still want to use my remote LED keypad for guests etc. In regards, arming and disarming, did you find a way of using the G4, does it have a hidden key switch setting? What was your solution.

 

[Jon Mac]

Thanks for getting in touch, I'm sure there must be a way, I was thinking of finding out how the set/unset input comes from the keypad and seeing if the konnected relay/momentary switch could make that signal thus setting the alarm but I'm unsure how to check this.

John

If you haven’t resolved your problem would you be willing to part company with your interface board. It sounds as though you actually need the new Konnected Alarm Panel board linked to the new interface add-on for what you are trying to achieve.

Jon

 

[drewzh]

I don't want to dig up an old post but info is scarce and I'm facing the same issue. Did anybody work this problem out in the end?

 

[drewzh]

I don't want to dig up an old post but info is scarce and I'm facing the same issue. Did anybody work this problem out in the end?