remove

Recent contents Top users
  1. 3

    Help. Socket removal

    I have been asked to remove a few sockets which are to be plastered over. It's part of the ring main so it would be easiest to connect them up box in tape up and plaster up.Is this ok? Is it the best practice? Can I do it a better way?Cheers
  2. N

    Idiotic instructions did make me laugh

    5ft light fitting opened the box , removed end caps ,removed diffuser , removed center contol gear tray found instructions and it read !! Firstly unpack your light fitting ....... Mmmm instructions are in the fitting how can i do that second remove end caps ...........Mmmmm instructions are in...
  3. J

    Changeing CCU and removing main head fuse

    Hi all, I am just finishing my Level 3 City and Guilds level 3. I am going to replace an old re-wire-able fuse type CCU with a dual RCD CCU. When replacing a CCU in the past i have just removed the main head fuse to disconnect the supply going to the CCU. But someone at my collage has...
    • justjust1
    • Thread
    • aus fuse main remove removing someone supplier tails
    • Replies: 129
    • Forum: Australia
  4. T

    HMRC plans to remove ECA for FiTs and RHI systems

    HMRC have just published a consultation document that expresses their plans to remove the Enhanced Capital Allowances (ECA) from any system that is eligible to receive income under either the Feed in Tariff (FiTs) or the soon to be introduced Renewable Heat Incentive (RHI). The changes...
  5. Goody

    To remove or not to remove the unused MCB's

    I came across a CU with one RCD. Two ring circuits are on 32 Amp MCB each and 3 lighting circuits on 6 Amp MCB each; the other MCB’s are left on the CU serving no circuits. Should I remove them and put blanking plates (plastic) to cover the hole or leave them there with label “not in use” This...
  6. J

    Earth leakage trip minor works

    Hi Looking at a minor works job in a flat, board which isn't split has a BS4293 RCCB as a main switch fed from an Earth leakage trip. I know both are obsolete and the SSC for the RCCB is 1500A. Am I right saying I can't just remove the earth leakage trip and replace the RCCB with a BS61008 as...
    • Just
    • Thread
    • aus earth earth leakage electrical work leakage minor remove replace switch trip works
    • Replies: 10
    • Forum: Australia
  7. W

    Starbreaker MCBs

    This is a really basic question. I have an old Crabtree Starbreaker c/u (dated 1992) that uses mcbs that slot in. Is there a recommended method to remove them as obviously I do not want to use unecessary force. The instructions tell how to intstal them but not to remove. Thanks, Paul
    • wansbrough0
    • Thread
    • aus bottom breaker mcbs remove
    • Replies: 3
    • Forum: Australia
  8. G

    Non paying customer - what are my rights??

    Hello all, I'm in a bit of a complicated situation and can't believe in the current climate that there isn't anyone else out there who has experienced something similair. I recently completed a rewire for a small building contractor, whom I have worked for previously with no problem but...
    • Goldsparky
    • Thread
    • aus builder customer paying payment problem remove
    • Replies: 4
    • Forum: Australia
  9. Jurassic Sparks

    free cable guide kit

    working locally I had a problem with an overheated cut out and was unable to remove it to start work (emergency job) so I nipped the seals of the meter to remove the tails then dropped my screwdriver down the back of a panel !!!!!!! luckily Maplins is over the road, walked in and they do a...
  10. C

    Old Style meter, can I remove it?

    Hi, I have 2 meters, one old day night meter and a newer one, can I remove the old meter as it doesn't really seem to be serving a purpose, its still ticking away and has tails to the cutout. Cheers in advance:)
    • cairns
    • Thread
    • aus meter old remove style
    • Replies: 7
    • Forum: Australia
  11. J

    Seal on cut-out fuse

    I have just moved away from commercial engineering including some electrical work. I sat the part P course at TS4U and now intend to operate as a self employed domestic electrician. Could someone tell me what to do if I had to remove the suppliers cut-out fuse? Could I remove it myself then...
    • Jeremy Martin
    • Thread
    • aus electrical fuse illegal isolator remove
    • Replies: 5
    • Forum: Australia
  12. E

    Service Fuse Removal

    Got wrong today :( problem with earthing at property, was splitting tails to install shower db had both a pme and tns setup, had a good ze for tns but also a bad read on the pme. got leccy board out and he had a go for pulling the fuse, and then he got on the phone to his office and reported...
    • ezzzekiel
    • Thread
    • aus chris fuse removal remove service their
    • Replies: 58
    • Forum: Australia
  13. S

    Bathroom Sockets in UK

    How can an electrical socket above the wash basin be made legal in the UK (Scotland)? We were puzzled that there were no electrical sockets in our newly purchased house when we moved to the UK 5 years ago. So we simply installed two sockets and a standard electric mirror cabinet (which provides...
  14. B

    can an electrician remove boilers cover?

    Hello everyone, I am thinking to do some practice on the boiler wiring in my own house. Can I take the boilers cover off? Some people say only gas safe engineer can do it. Is it true? Normally what need an electrician do regarding the boiler wiring, maybe only the wiring of the stat and...
    • bluesky
    • Thread
    • aus cover electric electrical electrician remove
    • Replies: 14
    • Forum: Australia
  15. I

    replacing flex cable on panel heater

    Hi all I was hoping for some advice. I have a dimplex panel heater for the bedroom however the location I want it means that the flax cable isn't long enough to reach the intended socket. I have some spare cable but I've hit a problem. When I tried to remove the current cable I wasn't able to...
    • itsmrb
    • Thread
    • aus cable check flex heater panel remove replacing
    • Replies: 8
    • Forum: Australia
  16. C

    Main EB fuse, Do we need to inform ??

    I heard that the Elecricity Board needs to be notified when removing the main fuse to change a CU, is this true or just when you have to cut the seals? as i knew it was their property but i've never known anyone to do this before ?
  17. T

    burglar alarm removal

    Hi Guys New to the forum. I was wondering if there is anything special I need to do to remove a ADP Alarm system someone has asked me to remove, Never really worked n alarms systems before so any advice would be greatly appreciated Cheers Tickover
  18. P

    Outside lighting and board

    Guys, been to see a job the woman just wants a dimmer switch fitted in her bedroom. I take it i don't need to do a mw cert for this and how much would you charge as will only take 5 mins and its only 10 doors away. She also said later on she will want some outside lighting. In the shed she...
    • Peter Woodford
    • Thread
    • aus board dimmer light lighting outside remove switch
    • Replies: 13
    • Forum: Australia

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Contractor Talk
Electrical Advice | Electricians Blog
Electrician Talk Forum
Tiling Blog
Tiling Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock