Discuss Connecting Dual RCD board. in the UK Electrical Forum area at ElectriciansForums.net
I stupidly bought a blank unit that only came with the main switch.Can we have a photo?
normally, the tails go into a main switch, then there are made up tails feeding each of the rcds from the load side of the switch.
These should be included in the consumer unit what purchased.
I don’t think these are compulsory yet?And don’t forget the SPD
I can’t seem to find a kit for dual RCD where the lives are linked. The other thing I’ve noticed is when you bend the tails to fit them it’s difficult to not have exposed copper, as the insulation pulls away. Any idea where you get shrouds from.Well, I think you can buy a conversion kit which has the right link cables at the right lengths.
your 17 way board will only be 13 when you add in a couple of rcds
Sadly too late for that. Unpacked, knockouts removed and fitted on the wall.If i were you i would return it and buy the correct board of a different brand. Or I would use rcbos and abandon the dual RCD plan, bg ones are not that expensive.
It's flexi tails usually used for dual rcd with crimped ends, not normal tails. I would use rcbos rather than building my own dual rcd board. Have you already bought rcds etc?Sadly too late for that. Unpacked, knockouts removed and fitted on the wall.
That’s fine, the ”customer“ is me. I’m a newby electrician, so I thought it best to make all the mistakes on my own house first ?not compulsory, but the customer has to "opt out" of having it.
I think Screwfix are trying to sell off their non-spd BG boards on special offers.
Same advert said "buy this, and get 25% off 25mm tails"
Yeh... on blue and brown 6181Y... no mention of the 6491X green/yellow
Oh baby,you not Fred dibners son are you. Lol.That’s fine, the ”customer“ is me. I’m a newby electrician, so I thought it best to make all the mistakes on my own house bang first.
The OP is a newly qualified electrician I believe.Hate to be that guy but - get an electrician in to do it.
I don't understand how he's here asking how to get tails into a CU into the bottom of the main switch. No offence OP.The OP is a newly qualified electrician I believe.
But how would a qualified electrician not know how to do that? Not bashing him, just confused.maybe OP is talking about the internal links to each RCD .
I wonder if, and again no offence OP, he did a shorter course or something?As I understand it, the OP is newly qualified… maybe doesn’t know how CUs are supplied, whether had to build them from scratch, buy them populated or part populated… split board etc. Lot to think about if you haven’t done them before.
At least he’s practicing in his own house.
Reply to Connecting Dual RCD board. in the UK Electrical Forum area at ElectriciansForums.net