High Ze causing headache !

[sythai]

Hi Guys

Any advice/ pointers would be appreciated

Have ‘pretty big’ new build house we’re wiring from scratch.

New supply in from DNO is PME, but we have Ze of 0.51

Are DNO obliged to keep this under 0.35?

Wouldn’t be that much of an issue normally if regular size house and meter was attached to house.

Before we came along on the scene Client had separate garage block built, meter permanently sited in here.

We’ve run a SWA sub-main across to house DB 25metres away, but struggling on suitable overcurrent protection. Even at 80amps BS 88…. Max EFLI 0.40!

Don’t really want to be putting new build on TT system, if it comes to it.

Thank you
Sy

 

[7029 dave]

Are you taking the Ze from source (at the new supply)

 

[Gurnatronics]

Listened to a podcast from the E5 group earlier today and DNO guidance states PME ZEs can actually be as high as 0.8. I will try to dig out the pdf

 

[buzzlightyear]

New supply in from DNO is PME, but we have Ze of 0.51

Have you spoken to the DNO about it.
They might sort it out.

 

[Julie.]

DNO is not obliged to supply Ze lower than 0.35 ohm; although all DNO strive to achieve it.

It appears to be a common myth!

Edit:

And why on earth (sic) would you consider changing it to TT?

 

[SJD]

Two 60A / 63A sub-mains, to two separate DBs in the house, circuits suitably divided between them!

 

[Aaron b]

Is it the Zs of the sub main that is high or the Ze in the garage block? What size is the SWA?

 

[Deleted account]

if disconnection times cannot be achieved by the Breakers then residual current devices can be used.

no need to TT. a PME with a slightly high Ze gives a far better EFLI than any TT could achieve.



although a combination of earth rod and pme may be in order in case of dropped neutrals, but that’s a whole different thread on an abandoned proposed reg change.

 

[sythai]

Are you taking the Ze from source (at the new supply)

reading at cut out

 

[sythai]

Listened to a podcast from the E5 group earlier today and DNO guidance states PME ZEs can actually be as high as 0.8. I will try to dig out the pdf

I did hear that a while back.... that they wouldn't be concerned unless above 0.8! But always hoped they wouldn't go by that